Reviews
Installed on TT250R
[How is it used? As I said, it's been almost 40 years, so Bellows no longer works.
Was the one you received as per Image? Mostly Image Resistor
Was the installation difficult? Band could use OEM.
How was your experience with it? No problem
[Was there anything that disappointed you? Could have been a little darker Blue.
▼ Other items like this would be helpful. In addition, I changed the Fork oil.
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
View detail
The drainage holes are in place.
[How is it used?
The Fork Boots I had on before my SEROW 225 were falling apart and torn, so I bought these to replace them.
I was troubled with the Neoprene gator of Achal Screw which looks good Parenthesis and is inexpensive, but I heard that there is difficulty in durability and finally settled on this one of Orthodox bellows type.
Was the one you received as per Image?
ImageThe texture was better than I had imagined.
There was also a drainage hole.
Was the installation difficult?
I had to remove the Fork from the car body to install it, and it was actually my first time.
I took it off with instruction and put it on over the top.
How was your experience with it?
So far, so good. Well, I'm just covering it.
If you get a chance to drive in the rain, you'll want to check the drainage holes to make sure they're working properly.
Expect durability from the texture.
[Included Parts:were they on?
It comes with 4 Tie Wraps. Also, it came with a PROGRIP Sticker.
[Was there anything that disappointed you?
None in particular. Satisfied.
Other items that would be helpful
Installation Point or hang
Tightening the Tie Wrap is the final step after the Fork is reinstalled and secured. If you use the Tie Wrap to secure it before that, you will have a hard time. Like me.
View detail
I'm happy with it, but don't forget to check the size
I was wondering whether to use OEM or DRC because the SL230 OEM was torn, and then I found this The inner tube diameter of SL230 Initial Model is 35mm, so I decided to use Small Select Type
The texture looks good when it arrives
However, when I installed it, the Inner Tube side was Exactly, but the Bore Side was I didn't check the size of the Outer side only on the Inner side I..
There's more than 50mm on the Outer side …
It's not going to fit even if you stretch it out, so you have to make an incision to attach it
Because I stretched it out and put it in, the air release hole stuck to the outer tube and the stroke The ShoeShoe sound comes out every time the W
It took me a while to get my own poka, but I was able to replace it for about half the OEM price, so I'm happy with it
Not related to the item, but it's a bonus? Sticker of the W was in the Large amount
View detail