Reviews
Just a Washer.
It's just Washer.
It is just a Washer with 22mm OD, M6 hole, 1.6mm thickness.
I said it twice because it is a Large thing.
We had no choice but to purchase the Bar End because the part in question, which had been stocked, had gone missing.
It may seem that Large is sturdy without it, but in fact, if it is not installed, the Bar End may easily fall off, cannot be firmly fixed, or may interfere with the Throttle.
So it is practically an indispensable component.
It's just a Washer. (Lol)
Considering the price, if you have the time, it is much cheaper to buy the same Size at Home center.
I didn't have Timing to go buy it, so I bought it on webike.
View detail
This is the first Mud Guard I put on.
I finally settled on HURRICANE's Mud Guard, but before that, I bought this one and put it on.
I thought it looked good, so I put it on …
good point
The thin aluminum board is stylish.
Easy to install with the Tie Wrap.
I can cover small stones to some extent.
A bad point
Stylish is fragile and contradictory.
The Tie Wrap broke easily and fell off the body.
The Mud Guard I bought was cheaper and stronger than the Mud Guard.
It may be wrong to ask for strength in the installation of Tie Wraps, but I think it is safer to use a manufacturer that specializes in Gold Parts, if it is a Gold Part.
To each his own, though.
View detail
Unlike Image
Together with the License frame it was not so good.
I just thought that I chose it by color, but I thought it would be more clear.
View detail
I do not know.
Although it is before opening it has scratches like the view.
Worth 1,000 yen in 4 cases - - - How is that?
Bolgarage's Bolt cap is enough.
View detail
Save your money, way overpriced and poorly finished. I had to re-drill the washers attached to the mesh in the covers (which appears to be glued onto the mesh) The trim didn't fit properly so I had to clean it up and re-glue it. It was fairly simple to f
Save your money, way overpriced and poorly finished. I had to re-drill the washers attached to the mesh in the covers (which appears to be glued onto the mesh) The trim didn't fit properly so I had to clean it up and re-glue it. It was fairly simple to fit (after fixing the problems) however the instructions were only in Japanese and the pictures were tiny. The covers look ok if directly side on however you can see the throttle bodies if you move slightly to the side. Will try and take a picture soon. Did I mention it was overpriced, half its asking price was more appropriate. I am worried about ordering the cafe conversion set now. View detail