Reviews
Too easy to fail.
I had an FXBlinker installed and wanted to change to a Refreshing Blinker. It was a simple job of replacing the bulbs and wiring. When I asked the Motorcycle shop to check the operation, they told me that the aluminum plate holding the bulb in front of the right side had popped out and caused contact. I was stunned at the messy construction.
It is my fault for not checking, but I had no idea it was that easy to build. However, I like the design, so I had it fixed and will use it as is.
View detail
No operating noise.
There is no operating noise. It is Relay that chooses the body of the vehicle. View detail
No operating sound.
I bought this for the sound it makes as I am getting older and forget to turn off my Blinker. Is it because it is an LED Blinker? It's a shame because it's made in Taiwan and I could have bought a normal Relay for 350 yen on Amazon! 。 I feel like I've thrown away more than a thousand dollars in gold in a ditch. View detail
Does not fit the ZEPHYR1100 OEMHeadlight!
Webike I was informed that it fits by the confirmation answer, but I was not able to install it because it is smaller than the OEM Headlight. View detail
I'm compatible with the installation!
It is not fixed completely even if the bolt for the lock is tightened though it is about the installation with Square Type Blinker of the same manufacturer. If you don't take some measures, you will have wobble. View detail
Casting & Plating Quality
The styling is perfect for my Z1, much smaller than the orignal blinkers, but the casting & plating quality is terrible. I exchanged them for another set. View detail
Fits: HONDA CB400FOUR (water-cooled), HONDA CB750 Fore (CB750K), HONDA CB750 Fore (CB750K), HONDA CB750 Fore (CB750K), HONDA CB750 Fore (CB750K)
What is it?... Mr. Webike is just such a thing...
In my case my friends are CB 750 four so I noticed that I noticed that the Motorcycle shop who went and reached in that relationship is specializing in CB 750four, so it is understood.
First of all, although it is engraved with made in japan, making is a little as much as I think whether it is made in a certain country.
1. The SIDE Reflector and the bottom Clear board for Number lighting are not flush but protrude and glued. It is uneven..
2. I do not know whether paint or Clear is blowing but the surface of Lens is tough and there is considerable color unevenness in the red part. It is Muramura.
Compared to another Manufacturer's Remake item that Motorcycle shop recommends, there is a difference that everyone can understand by looking at it. It's Level that says this is like shine and gloss.
It is shocking..
3. At that time Remake's new item recommended by Mono and its Motorcycle shop has a Reflector of Plating paint inside. Because there is it, light reflects at wide angle, Tail glows well and Number also lights with chitin.
I do not have such a thing like Large. It is a skusca..
4. Although it is a miscellaneous part of the largest Large, Large Kimono is different from the beginning. It is obviously a big deal.. At that time it is not quite as doubtful that this Lens is really attached to the Body of the thing.
When aligning with the hole of Rear's FRP Fender, the positions of Screw and Bolt are almost same and there is no problem.
However, since Lens and Body are Large, I think that there is no problem for ASS purchase, but it seems there is a possibility not to be attached when exchanging either one.
All of the above are for specialists "Is this Remake item something bad?" It is understood from comparison of the thing at that time with thing of Remake of another Manufacturer and this product and it does not appear at all about PMC and Webike's product introduction.
Since I had something like the above, I immediately repurchased the item I recommend for that Motorcycle shop.
Like me "I would like to add a kitty and Beauty items if possible" And "Remake items similar to those at that time if possible," I definitely are unsuitable for those who think that.
However, I think that there are also people who say anything is fine, I think that there is no problem for that person.
Compared with other Manufacturer's things, Manufacturer and webike think that it is better to question and ask questions frequently.
View detail
It will not blink, if a Blinker is all changed into LED so that the direction of others may say. Since it is , it purchases, and it is satisfactory and I can be using the object for Addresses v125 made from a KITACO.
It will not blink, if a Blinker is all changed into LED so that the direction of others may say.
Since it is
, it purchases, and it is satisfactory and I can be using the object for Addresses v125 made from a KITACO.
View detail