Reviews
Baptized Design!
I think it's a pretty cool design! Vibration proof and single cylinder Motorcycle
But it doesn't sound scared, so it's RECOMMENDATION!!!
View detail
Fits: YAMAHA MT-03, YAMAHA MT-25, YAMAHA YZF-R25, YAMAHA YZF-R3, YAMAHA MT03, YAMAHA YZF-R3, YAMAHA MT03, YAMAHA YZF-R3
Rear will be cool!
I bought this one because I liked the position of the Blinker the best.
The Wiring also fits in the Cover to some extent, so there was no problem even if it rained a little, although I did not apply any special waterproofing treatment etc.
View detail
It's nice
I bought a used TRX850 that was a Fender Eliminator with a Silver T-Bracket and a square Reflector.
The bracket is black and I like the shape of the Hexagonal, so I bought it.
It's better now. If I could do a little more reduction in cost, it would be great.
View detail
For weak legs and feet (laughs) a twist
I used Magic tape to attach it to the Tank end for Breaking and Machine Hold in Circuit driving.
You can add a piece or two to the Position of your choice.
I did not hesitate to fail because of the low cost.
It's very good.
View detail
Design is a good idea (depending on the type of car and the direction you are going).
The size is the same as the image.
The mounting is done by friend-tightening the NumberMounting Bolt. In some cases, it may be better to increase the bolt length by 0.5mm.
I love the fact that it is legal without interfering with the Image that I want to lighten the Rear under Number and without being too assertive.
View detail
Good??
I think that anyone can exchange it.
It's clean because Bolt is fixed on Main plate.
Because all OEM Parts can be used, other than Kit is not necessary.
View detail
As this is called Original?
Black Looking for a way to make it fancy without painting a car that was one color, we decided to buy it here.
Examining and selecting Unicorn.
Thanks to Hide and kitchen two transformations, I became able to call out occasionally.
Use the Net to inspect it, paste hard with soapy water and Dry ya.
Even if it deviates somewhat well Warge OK!
After pasting for more than half a year, the edge end was peeled a little bit, but again, using Spray garbage every time things are not completely removed.
However, because the Instruction Manual drawing at the pasting position was not easy to understand, it is unknown whether it was truly attached to the same place as the intention of the producer.
If possible we wanted the drawing to be prepared to be similar to the appearance of Motorcycle.
View detail