Reviews
It's firmly attached.
I had a 10mm wide tape and could have attached it side by side with sufficient strength, but I decided to purchase the Seat type because I thought a single piece would be more secure.
Some products are labeled as heat resistant, but this product is also heat resistant. Operating temperature range -20 to 150 degrees Celsius. The product is designed to withstand even midsummer in a car.
This product is slightly thicker, and its elasticity and neSpringba make it more difficult to cut out, so the cross section will be rough if you do not work carefully with a well-cut Cutter.
The adhesive is strong enough. As a basic rule, degrease the surface to be pasted firmly, and work to paste it in one shot at the targeted position.
The price seems high for Size, but it doesn't seem to fall off while driving.
View detail
Powerful
I needed to reattach the Bracket to attach the Camera to the Helmet and purchased the Seat type.
I have been using a bracket of the type that can be attached to a rec mount in order to operate a Camera that is used as a DriveRecorder by attaching it to a helmet. Previously, I was using DAYTONA's DDR-S100 attached to the helmet, so the Bracket was originally attached, but it was removed when the helmet was repainted, so it was necessary to prepare double-sided tape to reuse the Bracket. To reuse the Bracket, we needed to prepare Double-sided Tape.
Since it would be very dangerous if the Camera were to fall out of the helmet while driving, we decided to use a strong double-sided tape and a single piece of double-sided tape.
If it is for the inside of the car, we had Seat type Double-sided Tape in stock, and it seemed to have enough adhesive strength, so we thought about using what we had, but since we cannot say that there is no possibility of driving in the rain, we purchased Double-sided Tape for the exterior that seems to be strong against wind and rain, just to be safe. However, since there was no guarantee that I would be able to run in the rain, I decided to purchase double-sided tape for the exterior that would be resistant to wind and rain.
Since this product is rather thick, it would be better to use a cutter that can cut well when cutting it out. In addition, although it is a basic thing, I think it is better to clean the surface to be pasted, to degrease it firmly, to paste it in one shot at the targeted position, and not to mess with it for about one day because it is not firmly attached immediately after being pasted. As for the cutout, the cross section was rough because it was inevitably cut by hand, but generally, I think it was pasted in a good way. Since it is firmly attached, it is unlikely to be dropped while driving.
The price seems high for Size, but I am satisfied with the results as expected.
View detail
At the time of Tank replacement
I used it to transfer the remaining Gasoline to my car when replacing the Motorcycle Tank.
I think it depends on the shape of the Tank, but we were able to empty the Tank almost completely with only a small amount remaining.
I could not transfer it from my car to my Motorcycle because I could not reach the Fuel Tank. (I guess it depends on the car model)
Also, the smell of Gasoline is hard to remove, so don't store it indoors after use.
View detail
Battery brush
I had never heard of a product called Battery brush and the price was reasonable, so I bought it to try it out.
It is surprisingly more usable than I had imagined.
Brush can be used outside of the Battery terminal with good hardness.
I would like to use it for a while and buy more.
View detail
Generally the same as Velcro, Inc.
Used to fix ETCUnit attached to VTR-SP.
I was using the extra Velcro from Velcro that originally came with Power commander 5, but it was coming off due to lack of area, so I used an additional Emon product.
The performance of the Magic tape was not inferior to that of the Magic tape, and it was firmly fixed in place.
It is a little looser than Velcro, but Velcro is too strong to begin with, so it is just right.
The performance of the double-sided tape section is generally about the same or slightly stronger.
Velcro is a USA product, and the double-sided portion is strong, but this product from Emon also sticks firmly.
This area is very different from the cheap 100s.
However, the double-sided portion is quite weak once it is peeled off, so it is a one-shot deal and requires careful positioning.
There is no Negative in particular, but if I had to say, I would say that a little more quantity would be nice.
But since the original Velcro is sold in American style with the smallest length being 46cm, and the price is a little expensive in Japan, it would be more convenient to sell it in a cut-off size with a length and price like Emon's.
View detail
non-greasy
Vinyl tape is fine, but vinyl tape makes the Cable sticky, so this Binding Tape is used.
It can be used for a variety of purposes, such as cable bundling or at the end of a Colgate Tube.
View detail
Easy to use
I used this for wiring the USB power supply, and the red wire of DAYTONA stands out, so I used the Wiring Tube and this as a blindfold.
Easier to use than Vinyl Tape because it can be torn off by hand, and easier to bundle and protect wiring that might rub against it. And it looks better, too!
View detail
"Japan" No glue residue after peeling off.
It is used to fix PPMaterial and slippery PlasticMaterial, which are not common in Motorcycle.
Don't expect too much, though. It's much better than nothing." Therefore, we are actively using it.
At any rate, it is inexpensive and I strongly recommend using it on a trial basis!
View detail
That would be handy
Bracket used to stop Wiring, 1Quantity:Set contains 8 pieces.
I often use it for in-house Wiring of cars and I also use it for Motorcycle as you can see in the picture.
Thin Wiring is fine, but thick Wiring is not very suitable.
The clasp is made of soft gold, but this means that it is easy to open, and if you hold Wiring from below, it will eventually loosen.
If the Bracket is placed in a direction that does not require any force to open it, there should be no problem.
The adhesion of the double-sided tape is neither good nor bad.
If you apply it with a good surface preparation, it will hold up reasonably well.
It is a useful tool that is easy to use.
View detail
25mm
When wrapping tape around a long wiring, it can be wound faster than the commonly used 19mm. It is also easier to work with because the glue is less sticky. The disadvantage is that it is expensive. View detail
Amon tape 1777
This not bad but thing protective layer I'm using in engine bay area wire protection.fellig less stickey.this good for automobile DIY enthusiast.thanks amon View detail
Just a thread. But easy to use.
I used it to strip the Emblem from the OHLINS.
There are similar products, but this one did the job.
It is just a thread, but it can be peeled off without damaging the Body.
I love that it comes with a replacement thread too.
It was a pretty strong adhesive, but it came off cleanly when I hooked the thread in the gap and pulled it off.
I don't use this product very often, but it's safer to have.
View detail
Useful for a wide range of applications
The adhesive strength is very good and heat resistant, so it can be used effectively for both interior and exterior. It can be used to install ETC and other devices inside the car and Aeroparts on the exterior. Water resistance is also good, so it is easy to use for DoorVisor. View detail
Transparent and unobtrusive
Clear type double-sided tape is ideal for attaching the DriveRecorder Body to the front glass. [Color] Since it is clear, it is not noticeable even if you look at the surface from the outside of the front glass. Moreover, it is very strong and resistant to heat, so you don't have to worry about it falling off. View detail
It can be used for many things.
The wide range of size and sufficient length makes it convenient to use in various ways, and the double-sided tape is effective for matching Rubber and Gold genus, which makes it easy to apply Weather striptease and Rubber molds. View detail
It is useful for narrow places.
The Connector is easy to unlock and easier to work with than prying with a Wiring Screwdriver. The Grip is easy to hold and effective. It is possible to use it to hook the Gasket which stuck and to remove it, and there are various usages. View detail
It is easy to Cut.
You can easily cut the tape by hand even if your hands are not free for work and it is difficult to use Scissors. The tape is easy to use because it does not get sticky due to heat. View detail
It's super powerful.
This double-sided tape is very strong and sticky, it's very convenient for Aeroparts installation and it's easy to use when you need to install or repair your Aeroparts. The tape is very strong and sticky. View detail
It is very durable.
Thin, yet strong and easy to use hand-held non-woven tape, useful for tying and protecting Harness, less sticky, but still sticky and heat and strength resistant for use in the engine room. View detail
The quality is different from Vinyl Tape.
It is not easy to stretch even if you pull it, and it can be cut easily by hand. The stickiness is not sticky in spite of its firmness, and it is easy to peel off even if it becomes old and convenient for binding Wiring. View detail