Reviews
Stop guessing and use this tool to set your oil level.
Easy to use, clear markings on the tube. My only complaint is that the tube and hosing can separate when attempting to push fluid out of the syringe back into the fork oil container too quickly and creates a mess. A small hose clamp might solve this. Another one of those tools you don't really need but makes the job of adjusting fork oil levels a no brainer. Between the dirt bikes and mountain bikes this will pay for itself and allow making adjustments much easier. And, if you can let your buddies borrow it if they buy the beer, it is a win win. View detail
Easy to use.
I bought this for servicing an acquaintance's Address, but bought a 46mm usable one to use for servicing MAJESTY 250.
The clutch can be easily disassembled and is firm and thick enough to be used safely.
View detail
I'm just saying it's easier to do without.
I used it on a Clutch Wire that had become reluctant. I'm not sure if it's a good idea, but I think it's a good idea. It's a must have for me because I'm a bit of a pain in the ass. It is a must have for me as it is very cost effective. View detail
It's easy to use, but you'll start sweating from the Hose part soon.
Purchased in conjunction to get in tune.
It was easy to use, but it makes me sweat right out of the hose area.
I'm not sure if the Hose is properly Gasoline resistant.
It's not a problem, though, because I don't use it often.
View detail
It keeps the work area clean.
There are two types of Axel warmer, one to pull and one to put back, and by all accounts there's no gap to point the Nozzle through, so I think this is now a necessity, whether it's WAKOS, CRC, or whatever it is, it's a necessity for a motorcycle that's out in the field. View detail
Weight roller replacement
I used it to change the weight roller and it was my first time to do so, but it was done
However, I won't be using it for the time being
As a Sunday mechanic, this is good enough for me
View detail
It is cheap and a good Holder
Everything that comes from any Manufacturer has hardly changed
I bought the one with the cheapest KN project
Usability can be used together with Pulley face
Of course it can also be used on the Driven side
Because bar sticks are both tightened at the edge and Nut is removed, the part of the bar can be removed
It can be done as needed
Adjustment of the ring part can also be adjusted to 3 stages Can be changed by the butterfly Screw part of the horizontal board
View detail