Reviews
Effective
I use thin Gloves as I use the Handlebar Cover and Grip heater in winter on my PCX125 for commuting and I use thin Gloves.
Then the Brake lever is cold, so I installed this Sponge.
The effect is Large, but I take it off in the early spring because it will be cut off from the edge.
I wish it was a little more durable and 2Season usable or cheaper.
View detail
I think it's good for Parenthesis.
Installation is also very easy, just plug it in.
There is a bit of an Impact around the Grip and it looks good.
I will only use one because it's a LITTLE CUB, but I'll keep the other one in reserve.
View detail
I ruined one of them, but I still want to put it on without giving up.
This is a universal product, so it's not always the same, but it's a good idea to pass it through the diameter of the lebar end. The hole was too small to fit it well. The Clutch Side was installed with better slippage, but the Brake Side was installed while I avoided it.
I couldn't give up, so I bought another one and put it on. When I borrowed a compressor and installed it while wiping the air, it was possible to install it without difficulty. Because there is no Air compressor in the home, I will think about it. However, when the hole is made Large, it is said that it is one advantage and one dislocation after the installation. I think.
Personally, I can't feel the coldness of Lever in the winter and BrakeTouch is anti Linear (lol) is literally a good Cushion for me, as I'm not a good driver. It has become. Even though it's an inexpensive product, I lowered my rating a bit because it was difficult to install, but I'm sure it will continue to be ruined and I think I'm going to buy more and repeat the process.
View detail
The coldness of Lever becomes hard to be transmitted
Winter Spec. Mounting to make it.
By attaching it, the coldness of Lever became less overwhelmingly transmitted.
To say greedy, I thought that Lever touch would be difficult to change by making Sponge a bit more waisty.
View detail
The way to which this product was attached individually thinks that it is easy to carry out operation of a Lever. Since it could be satisfactorily used still now although there was also time, such as rainy weather and open storage, for the about fiv
The way to which this product was attached individually thinks that it is easy to carry out operation of a Lever.
Since it could be satisfactorily used still now although there was also time, such as rainy weather and open storage, for the
about five years, but degradation had been seen a little [
], it purchased newly.
Isn't durability also rather good, considering the
Cost?
I think whether to be easy to equip with
attachment, if a Silicon grease is applied lightly.
View detail