Reviews
Due to the depletion of OEM parts …
If you drive an old car, one thing you can't avoid is the end-of-life of OEM parts You can still get parts that are not related to driving, but you can even get parts that will be undrivable if one goes bad Even though it's not going away, it's a part of our daily struggle
In my case, the Fuel Hose, which is attached and detached every time it is serviced, has deteriorated over the years and has become stiff and hard to avoid Gasoline leaked, and Fuel Hose is any oil/weather resistant Hose It looks like a good thing, but Racer replica, which has started to focus on mass centralization, is a good thing around here The design is also Limit, with intricate curved lines running through the Frame I am Hats off to the designers at the time, but it's a tough sell when these specialized parts are discontinued Even if Universal's Fuel Hose is used as it is, it will be difficult to use Gasoline's There is a risk of running out of supply or tearing while driving due to unreasonable bending of the Stress This is where the L-joint is needed
There are not many L-shaped hose joints with 10mm inside diameter that you can choose from, and they look messy when you put them on Honestly, I didn't want to use it too much, but I can't whine about it because it makes it impossible to run No I've only tested it for a few dozen kilometers, but so far, I've been able to find a gasoline leak and a flow rate of I don't feel a shortage The only thing I didn't like was the looks, which was a far cry from the old Ka Chica Chi Hose The supply of parts for old cars is getting tighter and tighter every year, but it's safe to say that we can extend the life of the car with some ingenuity like this! I have done By the way, the inner and outer diameter of the Horse may shrink with age, and may differ from the actual measured value Please be careful when you do so
View detail
Worn for insurance purposes
Purchased on Amazon on 05/22/2018
Fortunately, I haven't come across a situation where I have to use it yet, but I have to protect the Radiator in case of an emergency I installed it with the expectation that it would be installed It is designed to interfere with the Cowl in installation and comes with an interference material
It may not look like it, but it gives you peace of mind if it happens
View detail
Functionality, quality, price are both GOOD.
It is a non-defective item with three points of functionality, quality and price.
Heatproof temperature (120 ° C) Oil resistance temperature (100 ° C.) It is safe to use because both are specified.
Because it is rich in elasticity, it is easy to exchange and good handling. I think that it is even better if the color is Black instead of Gray.
View detail
From now on is a classic
It is useful for protecting Hose, Wiring
The feeling of use was good for sliding and it was used for MeterWiring and Hose kind around Handlebar
There is a sense of security that can be protected, and Hose and Wiring classes also move to Smooth.
Since the weight of the product itself is almost none, it can be used without difficulty.
It is a place I want to handle well.
View detail
Fits: HONDA monkey, KAWASAKI KSR110, HONDA CUB [Cub]., HONDA monkey, KAWASAKI KSR110, HONDA CUB [Cub].
The shape of Tappet cap is adjusted and Large satisfied
Since I replaced it with Tappet cap of KIJIMA, I thought that I wanted to match the shape anyway ~ I searched and found that I bought it because it was Hit.
It is satisfied because the shape is the same for IN side and OUT side.
Special, damaged, leaked Oil etc. Because it has not woken up, it seems to be used for a long time.
View detail
It is also a Harness tube with fashion characteristics
HeadlightSmall Used when organizing and unnecessary Harness sorting which became bare with Type.
As stretchable as the product description, shrinking the Tube itself expands the diameter so Harness insertion also goes very smoothly.
As a precaution, since Tube is knitted, use of things that do not match in diameter will unbind both ends, so we recommend using things that are right for the place of use properly.
Heat-resistant - Although it was purchased because it was excellent in abrasion resistance, it was a very pleasant miscalculation that getting better looking and becoming a Dress-up effect too! (It was very cool and bad that the bare Harness kind is visible ...)
Not only Harness but various Hose and Wire - Since it seems that unified feeling is likely to become even more by using it for Cable, I will buy things of different diameter.
View detail
Used for Oil catch tank
I bought it for connection because the inner diameter of Hose connecting to Hose and Catch tank from the car body is different.
The price is reasonable and it is saved because Clip is also included.
View detail
Used with Wiring's Smoothing
Headlight - I used it during the Wiring process accompanying simplification around Handlebar.
It is deciding the purchase that it is excellent in abrasion resistance and also excellent in heat resistance.
Besides the above performance, it looks and feels better than Wiring Tube like the conventional Vinyl type, it also becomes Dress-up around Handlebar! (Us, that Dress-up effect is my 1st favorite! It is self satisfaction ...)
Since TubeSize is also richly lineuped, it is also good to be able to choose what matches the thickness of Harness.
If you can only say it, I would be happy if you could hold down the price a little more ...
Anyway, Handlebar around etc etc. Protection of the exposed portion of the Harness and Custom (Although it may not be as good as that) It is a perfect product!
Not to mention the performance, Motorcycle wants to stick to the looks ne
! (I am also satisfied with this again!)
Because it is a stretchable Tube, it is easy to install, Recommendation!
View detail
Products of OEMLevel
There is also an inexpensive Hose, but the quality is not good and the Clamp part is around
I get cracked. I do not leak, but it feels bad.
But if you arrange with OEM, it will be a good price, so after all KIJIMA
I continue using Hose.
Inexpensive and usable amount is exactly right for individual use.
As for durability as OEM same etc. I have more (The standard is HondaOEMHose)
View detail
One item as expected
I think that Hose itself is wonderful, but I regret that Hose clip is a skusca. I attached it to the Carburetor and fastened with the attached Clip but pulled out by hand to dismount it. View detail
It is Repeater!
Because it has heat resistance, I think that it is a good item for places that go near Engine. I think that the part that is not black is also squid. I would like to use this product from now on. View detail
It purchased with CARBURETOR exchange of RZ50.Although there were some whose inside cannot be seen with a heatproof like what whose a fuel hose is transparent and is visible, or this product, and oilproof, he gave priority to the heatproof and bought this
It purchased with CARBURETOR exchange of RZ50.Although there were some whose inside cannot be seen with a heatproof like what whose a fuel hose is transparent and is visible, or this product, and oilproof, he gave priority to the heatproof and bought this product rather than visible.Although it may be a problem of a feeling, I think that it will be stabilized that it cannot be easily influenced by engine heat, either.
It is kind if die length also has a choice and is cheap to a slight degree, if it says by force, and it can purchase.
View detail
An 8-mm Size was purchased.I think that I will purchase it next time also since the problem is an article which is satisfactory at all although it is which did not exist and which can just be regarded as somewhat larger than an 8-mm Size for the
An 8-mm Size was purchased.I think that I will purchase it next time also since the problem is an article which is satisfactory at all although it is
which did not exist and which can just be regarded as somewhat larger than an 8-mm Size for the
article itself.
View detail
Fits: HONDA ZOOMER(Ruckus), HONDA Byte
attaching, since it is a free Cap -- so and so -- it is not. Merely sell by a Set only!
attaching, since it is a free Cap -- so and so -- it is not.
Merely sell by a Set only!
View detail
Fits: HONDA ZOOMER(Ruckus), HONDA Byte
There should just be no hexagon head at a tip. It is wasteful. It will be the highest if it enlarges to a slight degree after . I think that Plating condition is good.
There should just be no hexagon head at a tip.
It is wasteful.
It will be the highest if it enlarges to a slight degree after
.
I think that
Plating condition is good.
View detail
I purchased for uniting two hoses. Although it is a simple connector, it would be troubled if there is nothing. Although Y type and T type are also required, of course, I think it would be convenient if there is two parallel exits like a tuning fork.
I purchased for uniting two hoses. Although it is a simple connector, it would be troubled if there is nothing. Although Y type and T type are also required, of course, I think it would be convenient if there is two parallel exits like a tuning fork. View detail
Fits: HONDA ZOOMER(Ruckus), HONDA Byte
It purchased together with the radiator tank. The condition of plating does not have a radiator tank and a difference, either and a feeling of unification comes out of it. We recommend you to purchase by the tank and a set by all means.
It purchased together with the radiator tank.
The condition of plating does not have a radiator tank and a difference, either and a feeling of unification comes out of it.
We recommend you to purchase by the tank and a set by all means.
View detail
Fits: HONDA ZOOMER(Ruckus), HONDA Byte
It becomes the cap of the radiator tank of plating out of which it has come as the option. It is a recommend which he unites this by plating and is bought. If a price is also only a cap, I think that it is not high.
It becomes the cap of the radiator tank of plating out of which it has come as the option.
It is a recommend which he unites this by plating and is bought.
If a price is also only a cap, I think that it is not high.
View detail
It is supple and management is easy than expected. Since it is a heatproof, on the vehicles along which a hose passes, I regard the neighborhood of engine as it being recommended. I think that I will exchange it periodically since it is or the res
It is supple and management is easy than expected.
Since it is a heatproof, on the vehicles along which a hose passes, I regard the neighborhood of engine as it being recommended.
I think that I will exchange it periodically since it is or the rest has how much durability, but it is also 1 m.
View detail
It is used for the circulation line of the liquid coolant of a zoomer (ruckus). The inside diameter 6 phi is a hose connected to the engine. it is easy to only substitute a hose -- since a liquid coolant is transparent custom and it is visible, th
It is used for the circulation line of the liquid coolant of a zoomer (ruckus).
The inside diameter 6 phi is a hose connected to the engine.
it is easy to only substitute a hose -- since a liquid coolant is transparent custom and it is visible, the circumference of an engine becomes gay and thinks that there is the remarkable dress-up effect up! although air-bleeding is needed, it can do comparatively simply and conveniently -- since custom, it is a recommend!
View detail