Reviews
Fits: HONDA CB1300SF, HONDA CB1300SF, HONDA CB1300SF, HONDA CB1300 SUPER BOLDOR, HONDA CB1300 SUPER BOLDOR
K-factory radiator core guard
Now if there is a difference in width size of the radiators I had to re-drill the holes on the side brackets by about 5mm each side then the cover slotted over nice and tight so expect there could be some adjustment needed View detail
K-FACTORY Radiator Side Cover
The radiator side cover was purchased because of its beautiful color, and the photo and the other side were very bad to install because of the radiator lid. It was very disappointing because it was attached and scratched all the surface of the product and was unsightly mounted. View detail
The correct Kawasaki OEM hose needed to install these water pipes is part number 39062-0262 (NOT 39062-026 as listed on the product page) Beware that the 39062-0262 hose from a Japanese DAEG is not available in the USA, so you won't be able to install
The correct Kawasaki OEM hose needed to install these water pipes is part number 39062-0262 (NOT 39062-026 as listed on the product page) Beware that the 39062-0262 hose from a Japanese DAEG is not available in the USA, so you won't be able to install the pipe that attaches the water pump to the lower radiator outlet. View detail
Fits: HONDA CB1300SF, HONDA CB1300SF, HONDA CB1300SF, HONDA CB1300 SUPER BOLDOR, HONDA CB1300 SUPER BOLDOR
Tightening Bolt will distort the net.
Whether the width is somewhat wide or not, if you tighten the Mounting Bolt to the Radiator core, the network becomes quite distorted. I put in Washer and adjusted the installation of the net and Bracket to the extent possible, but it was useless. After all, Bracket was machined and installed.
It looks nice, but the part of the net is too bad LePera.
View detail