Reviews
![DURACON(R) for [Repair]Engine slider](https://img.webike-cdn.net/catalogue/images/62290/000LZBH0_TS.jpg)
Buy as Axle Shaft
I bought this for my Triumph STREET TRIPLE.
The part used was attached to the Axle Shaft of the Rear.
In a DIY job, I threaded all the way through the Axle Shaft and attached the DURACON I bought to each end of it.
The Swing Arm interfered, so I put a 27mm Socket in between, and it was very stable and easy to install.
It popped out a little like Peg, but when I knocked it down, I installed it on the ground together with Engine Guard, and the car body was not damaged. Especially the footpeg, before I put this DURACON like Peg, the footpeg hit the ground, and the footpeg was broken many times, and repairing and repairing was very Large, but it did not hit the ground at all, and it became the best finish.
Also, I've tried several Chinese DURACONs on Amazon, but they all shattered in one shot and were completely useless, but this product has a solid weight and doesn't seem to break easily. I'm glad I bought it.
View detail
Fits: SUZUKI GSX1300R GSX1300R HAYABUSA, SUZUKI GSX1300R GSX1300R HAYABUSA, SUZUKI GSX1300R GSX1300R HAYABUSA
Good
Unlike the other manufacturers, I liked that it was not very noticeable It may be the individual difference of the vehicle, but there was a place which interfered with a part of cowl and I shaved with File And although the tightening torque is described in the Instruction Manual If you tighten the torque, it won't torque-tighten I stopped to some extent and in some places So far, no oil leaks etc., so I'll have to wait and see View detail
YZF-R25 Quantity : Pair (for Left and Right) The position is different
Purchased for YZF-R25.
First of all, it is tough if Bolt of installation place is hard and there is not Wrench of Large eyes.
I could not get out of Small Hexagonal Wrench and licked the mountain a bit and I used an 8 mm hex socket for the Large Torque wrench and it was easy to remove it.
However, Quantity : Pair (for Left and Right) There will be a difference in the position of.
Right Side may be bothered because of the knee hit position.
Goods of K - FACTORY can be replaced without removing Cowl and where the price is somewhat cheap, but the place where the knee strikes is very MinusPoint.
For those who can remove Cowl we recommend other companies' products.
View detail
Fits: HONDA CB1100, HONDA CB1300 SUPER BOLDOR, HONDA CB1300 SUPER BOLDOR, HONDA CB1300SF, HONDA CB1300SF, HONDA CB1300SF, HONDA X-4
Attachment rather than practicality
Good as Attachment
When I opened Package
The print character has peeled off
Hide downward. (; ゜ ロ)
One Side, this price is too expensive ~
Quantity : Pair (for Left and Right) If it is ◎
As I like it, I like it
I will do it.
View detail