Reviews
More reliable and convenient than using old Tire
I used to replace tires by laying down old tires, but the last time I used OEM tires, they were so hard that I had a hard time and my wheel got scratches all over.
CYGNUS for 12-inches was a little expensive in terms of cost performance because I had bought two-by-four method lumber at Home center and made it by myself, but it was a hassle to measure and cut and there seemed to be some know-hows on crate size, so I bought it this time. I bought it this time because it was a little bit expensive in terms of cost performance.
As for ease of use, I used to put an old Tire underneath, but when I crushed the other side of the Lever with my knee to remove the Tire from the Rim, the force was escaping, so now that it is in a wooden frame, I can apply the force firmly.
And even when too much force is applied, the wheel does not collapse and contact the ground like an old tire, so it was possible to replace the tire without worry.
However, in the past, I used to remove the Tire frequently to use up the Tire in Circuit driving, etc., but recently it is only once a year unless I puncture the Tire, so I started to think that it would be faster and easier to remove the Wheel and have the Shop replace it with a Changer when I think of the time and effort required for disposal of the Tire and removal of the nechae of the Weight, etc. I started to think that it is quicker, easier and more reliable to have a Shop replace the Tire with a Changer.
*Recommendation because it is very good for those who are replacing it themselves.
View detail
easy to use
I use it on ADV160 when I'm waiting at a traffic light on a hill.
It is attached to a shrinking cord.
View detail