Reviews
Easy to insert into Fork
When inserting the STAND into the front fork hole, the STAND tip bracket is inserted at an angle,
It is a little hard to get into the holes. Once it is up, it is fixed perfectly, but it takes a lot of time to insert it into the two Fork holes.
View detail
Compared to Rear Stand
Hajimete STAND for Rear was easy to use, so I bought Front stand as well.
I also thought that when I bought Rear Stand, the handling Instruction Manual is miscellaneous for the products here.
The product is nice, but the Instruction Manual is bad and it is difficult for beginners to understand.
I looked under the Handlebar and peering in, I could see a hole in the Steering stem open.
This is the STAND which inserts the tip of STAND here and lifts Front tire with the lever principle..
Compared to the simplicity of Rear Stand, it is hard to use. It may be familiar.
First of all, it hardly reaches the hole of Steering stem. If it is NAKED it will be easy, but with Cowl it is hard to see, so the tip of the STAND can not fit in the hole. I fought for 30 minutes to raise the Front of Ninja 400. It will rise in 3 minutes if it gets stuck in the hole of Steering stem.
View detail
It's easy to use, but the price is high, is not it?.
There is no possibility of using it normally and there is nothing special to mention
It is good that the height is changed to some extent and Stem's Adapter is 6 types.
However, it is a difficult point that the price is high.
View detail
It is easy to use.
I used Roller to clean Wheel of Front, but it took a lot of power to turn Tire, but was troublesome, but J-TRIPJTrip Fork up stand makes it easy to use Lift up and is quite easy to use.
However, this making (Combination of just iron Pipe) I thought about this price.
View detail
Maintenance is to a tire change, and since it did not consider desorbing Faulk, this product is purchased. Since there is no sense of stability in the state where it is raising when raising not much, considering the safety at the time of work, the typ
Maintenance is to a tire change, and since it did not consider desorbing Faulk, this product is purchased.
Since there is no sense of stability in the state where it is raising when raising not much, considering the safety at the time of work, the type which puts a stand and raises it under a stainless is better.
However, since the frame of a stand does not come beside Faulk or a wheel, it considers [ that this one may tend to work and ] here.
Merit also with big not taking a place to storage, either.
View detail