Reviews
jtrip first time STAND
I don't know if I have ever used the L or V receptacles, but I was able to raise them easily for the first time. I use it for storage. View detail
Motorcycle Maintenance
Motorcycle STAND must be jtrip. It is indispensable for my work. I am very satisfied. The price is a little high. View detail
jtrip Front stand
It was easier than hanging the Rear stand. I use it for storage. View detail
I bought it again.
Cushioning was also available, and the receptacle on the Swing Arm itself appeared to be falling apart.
However... after I bought it, I realized that the raggedness was just visible, but in reality it was just dirt... You can't look at it when you are tired.
Compared to the cheap STAND L-shaped receptacles, the quality of the Cushion section is better, first of all.
The cheap ones are thin rubber boards, while this product is a thicker, slightly softer board.
Damage to the Swing Arm is definitely less here.
View detail
Maintenance Stand
This is the first time I have used the Maintenance Stand and it seems to be useful for cleaning the Chain. It is also good for storage. View detail
usually
It can be used normally. It is a first-class manufacturer, so you can use it with peace of mind. View detail
Rubber Receiving Straight
It is easier to use than the L receipt and can be lightly Lifted up.
I am also wondering about the durability of the Rubber.
View detail
Stand for Beginner did not fit and I purchased an additional one.
At first I was scared to do STAND Up and Down, but once I got used to it, it was easy. View detail
If there is a pin on the pierced type, the shaft will not pass through. I didn't check the model of the car that fits.
Unfortunately, the Shaft does not go through when the Pin is present, so I purchased an additional V receiver. I did not check enough for compatible (non-compatible) car models. View detail
Better than Hook type
I used to use Hook type STAND, but I changed to VPlate and will compare the two.
The groove of the shaft and the Plate mesh with each other, so the Quantity:Pair (for Left and Right) The stability of the system is stable with little blurring of the
Material:The plastic material provides good sliding and reduces the force required for Lift.
The Hook type can be scratched by rubbing against the Swing Arm if one is not careful, but the V-Type is less likely to be scratched because the roller part runs away from the Swing Arm to the outside.
Hook type has a risk of damage to the swing arm or the female screw when it falls over, but the Plate type does not.
As for the demerit, the Plate on the body side is more expensive and heavier than the Hook type, and the Roller itself is also expensive.
Plate is definitely better than Hook if budget allows, as Merit is the only one in use.
View detail
I think the price is a little high.
Front stand for Mini bike.
I used it in NSF.
There is almost no rattling, and it stops exactly where it is supposed to.
I would have liked to have something to prevent losing the Piece.
View detail
Put it on the Body...
I can't use it without it, so I bought it, and I want it to be Standard Equipment. View detail
Easy!
I don't believe in Side Stand when parking out of the house and stop here with WheelClamp.
Great stability, perfect for maintenance!
View detail
Required for Maintenance
Ideal for tire replacement or front fender replacement.
It is somewhat difficult to lift when using it, but the Stem Hole Type may contact the cowl, but this one does not.
No worries!
View detail
It's stable.
It is considerably more stable than the V-receiver. It's usable. View detail
Easy to lift.
Used on GSX-R125 with V-receiver. It is easy to use. I used to use one specifically for GSX-R125, but this one is less likely to come off the receiver when lifting it, and it takes less force to lift it. View detail
it's recommended
The wheels are large and roll well, so even the large type is relatively easy to use. There are a lot of these kinds of products on the market, and they are expensive, but I should have bought this one from the beginning. View detail
It is useful for maintenance if you have it.
[How is it used?
Used in Front and Rear Set for vehicle maintenance and storage.
Did you receive the item as per the Image?
It is not as good as the Maintenance Stand for Rear, but it is a product that is placed relatively high in motorcycle supply stores, so you can check the actual product carefully before purchase.
How did you like it?
When I used it for the first time, I was surprised at how convenient it was. It can be easily fronted up without any effort.
Since it is inserted into the hole on the under side of the Stem, it cannot be used for maintenance work such as removing the Stem, but it is very useful for holding the vehicle stable when removing and installing the front wheel, overhauling the front fork, etc.
[Points to note]
As mentioned above, this product is fronted up by inserting it into the hole in the center of the Stem's Underneath. Please replace the supplied Holder (??? I don't know the name of the part) with the one that fits the hole of the vehicle you want to lift up.
Since the length of the front fork and the diameter of the tire and wheel differ depending on the vehicle, please adjust the height to suit the vehicle (or to suit the maintenance work) before use.
How did it compare to other products?
I have not seen front stands of other manufacturers, but I think the usability of this type of stand is the same as that of the Rear stand. Related parts are relatively easy to obtain." I think the first strength of the company is that it is a good place to start.
Color line nap is abundant as well as Rear stand, so it can be coordinated with MotorcycleManufacturer's image color (it is very good parenthesis if the front and rear colors are matched).
0Other items that may be useful include
Point and hang of installation
As mentioned above, the Attachment can be adjusted to match the Stem hole and the height to match the vehicle, so make sure to adjust it to your Motorcycle first.
[ITEMS TO BUY TOGETHER
Unlike the Rear side, there are no additional components that must be purchased for the Front stand.
Several types of attachments that plug into the Stem holes are included, so keep them in a safe place so you don't lose them (you may need them when you change Motorcycles).
[Opinions and requests to Manufacturer
As with the rear stand, please continue the lineup for many years to come.
View detail
Parenthesis is a good partner for maintenance and display.
[How is it used?
Used for vehicle maintenance and storage.
Did you receive the item as per the Image?
As a maintenance stand, it is a very MAJOR product that can be found at any motorcycle supply store.
How did you like it?
It is very easy to use because it is equipped with rollers, so it can be lifted up without effort, and the fact that the rear wheel can be set free is very helpful when changing tires or maintaining the chain. It is also good for parenthesis as the Motorcycle looks like a Racer when not being ridden.
[Points to note]
This product holds Swing Arm Hook section (L-shaped Hook, V-shaped Hook, Shaft Type, etc.) are sold separately, remember to purchase the correct Hook for your vehicle.
I use the V-shaped Hook type, and when I am in a hurry or tired and my attention span is low, one of the Hooks is firmly in the Quantity.:I have almost knocked over my Motorcycle several times trying to lift it up without setting......................be careful.
How did it compare to other products?
There are various products that are less expensive and Parenthesis better than this product. Related parts are relatively easy to find anywhere." (If you want to buy an L-shaped hook when you switch to a motorcycle that is not compatible with a V-shaped hook, you can go to the nearest motorcycle supply store to buy one.)
STAND's Color line nap is abundant and can be coordinated with MotorcycleManufacturer's Image color (simply Parenthesis good!!!). ).
0Other items that may be useful include
Point and hang of installation
The height of this STAND can be adjusted to match the tire diameter of your motorcycle or to the height of the maintenance work you want to perform.
As I mentioned above, when Lift up, Hook is firmly in placeQuantity:Make sure it is Set before lifting.
[ITEMS TO BUY TOGETHER
Remember to purchase the correct Hook for your vehicle. If you have to reorder afterwards, you will not be able to lift up your motorcycle even though the STAND itself is right in front of you...which is a shame.
[Opinions and requests to Manufacturer
Color custom order PURAN would be even better....
View detail
J-TRIP J-Trip JTrip Front stand20
I used it on the front stand of a certain cheap product, but ZEPHYR1100 was too heavy for it, but the J-TRIP product has a multistage height adjustment system that allows for free height adjustment. However, the J-TRIP product has a multi-stage height adjustment system that allows for free height adjustment. However, the price is about double that of the Net product, so it is necessary to secure a budget. View detail