Reviews
It runs smoothly.
I put it on MeguroJuniorS7 with KITACO Rubber holder.
Thanks to the insulator rubber, there are no thermal effects, which had been a problem.
Smooth and stable running from idling to full throttle.
However, it must be Set up accordingly.
If it is shipped, it is too thin.
MJ130
SJ38
Second row from the top in Needle
It's not perfect, but it runs reasonably well.
View detail
I thought it was similar to CRcarburetor.
It was attached in front of the FCR Carburetor Body.
It doesn't have the acceleration pump, so it's not as good in that area, but it's not bad.
Response and high RPM growth will be much different.
The size is also just right for 250cc.
good point
It's about a third the price of an FCR Carburetor Body.
The setting is also easy to set.
It is more similar to the PC carburetor of CR and CUB series than the FCR carburetor body.
The appearance is also very Parenthesis-like.
A bad point
Aftermarket parts are difficult to obtain because they are imported.
As a result, I prefer the Japanese carburetor, but it's not that expensive. If you're looking for a cheap way to get more power, try Recommendation.
View detail
Fits: AJS Cadwell 125, AJS Cadwell 125, AJS Cadwell 125
That's not the picture
The contents are different from the picture.
The intake side is not mirrored and it doesn't have a fuel fliter.
I want it to match properly.
I also bought a Main jet and a Slow Jet because the Gas was too thick for the pontoon.
The Accelerator Wire is a little longer and thinner than the hole in the switch box so I adjusted it with Tape.
View detail
Fits: AJS Cadwell 125, AJS Cadwell 125, AJS Cadwell 125
That's not the picture!
The contents are different from the picture.
The intake side is not mirrored and it does not have a fuel fliter.
[Contents] and I want the pictures to match.
In addition, because Accelerator Wire is a little long, and is thinner than the hole of the switch box, I adjusted it with Tape.
Setting is too dense to pimp, so you should also buy Main jet and Slow Jet.
View detail
Fits: AJS Cadwell 125, AJS Cadwell 125, AJS Cadwell 125
That's not the picture!
That's not the picture!
The intake side was not mirrored and it did not have a fuel fliter.
firmly [Contents] and I wanted the pictures to match.
Also, the size of the hole for attaching the Throttle Wire to the Switch box was not correct, so I had to adjust it with Tape.
Quantity for car model:Isn't it Set?
View detail