Reviews
Defective in protective rubber
When I tried to charge the battery, I removed the BlackRubber that is attached to protect the important parts of the Power Supply Cable etc. and bent it slightly, and the part connected to the Body was cut off. Since the body and the rubber part for protection are now separated, I have to be careful not to lose it when I charge the battery. I was disappointed with the quality of the product and was dissatisfied with the defects that occurred immediately after opening the package. Is it really JAPAN? View detail
It may be an individual difference, but Camera broke after less than a year.
I use two units.
One of our RearCamera units became defective after about six months.
I can say that it is to the extent that it is, well, I pulled a HaGap, but I am slightly unconvinced by the operation.
When there is a problem with the Camera, the LEDIndicator on the Switch blinks to let me know, but for some reason, other functions are malfunctioning in various ways.
It is supposed to connect to my phone via WiFi, but the connection is very unstable, and for some reason I could not connect to the Android app, even though the WiFi itself is connected.
Naturally, you cannot drop videos to your phone via the app, you cannot sync clocks, etc., and you cannot change various settings.
At least, the recording seems to be able to continue only with an active Camera.
I suspected a problem with the Body, but since I have two cameras, I tried connecting only the Rear Camera, which showed a problem, to the other Camera, which had no problem, and the application was connected and settings were available.
The LED indicator also seems to be unstable and may or may not display the status of a defective RearCamera, so I think it is better not to trust the operation when there is a problem.
If everything is normal, the camera is Large sturdy, so it might be a good idea to try connecting to WiFi once a month even if there is nothing going on, check if the app is connected, and check if the video is taken properly and the Camera is working properly.
The images that are taken are good enough to check the number of oncoming vehicles, etc., so the performance in that area is adequate.
View detail
as always
The Plate is not so bad, but the SMARTness after installation is good. View detail
Best installation method
The most difficult part of installing a Camera is securing the mounting position. This product is easy to install, looks unobtrusive, and fits in the refreshment area, so I think it is the best installation method for the Rear. View detail
That's what I'm talking about
I have been using it on my Camera Mount and have been trying my best to use the accessory type until now, but it broke, so I replaced it with a complete set made by Ram Mount and I am very impressed with the excellent feel and texture. View detail
EDR21A
We chose this product because it had good reviews and ratings.
The quality of the product was good and installation was not difficult.
The installation took about 3 hours, but it took longer with the Wiring routing, Cowl removal, etc.
The picture quality is satisfactory with almost no blurring, as I had checked on YouTube, etc. The Body is installed on top of the Battery under the Seat, and it fits well.
Microphone sound is also picked up at just the right volume.
I check the video by unplugging the SDCard from the Body, and the app is easy to use. There is also a way to connect to your phone via Wi-Fi and Download, but other people's reviews show that it takes longer with IgnitionON, so if you are concerned, it is better to unplug the SDCard to watch.
Overall, a very satisfactory product.
I don't know about durability as it has only been installed for a short time.
View detail
Good product.
I purchased MITSUBA based on your Review!
The Large size of Body is a little too large and the length of Camera's Wiring is a little too long.
I am generally satisfied to the extent that I was concerned.
Wiring on the Rear side is left over since the F/RCamera is common.
This type is not a problem because Space under Seat is wide Large.
I think the storage of Body and Wiring is Large in SS and SF Type.
I use Wi-Fi to check the video, but I can't get a connection in Preview.
I heard it was bad, but I had no problem with it.
*It was × on Android, so we supported it on iPad.
The video and performance are beautiful day and night with no problems, so the quality is ☆×4
As for durability, I just installed it. I'll give it a star×3
It is unclear what will happen in the future with warmer temperatures and the rainy season.
So far I think I made the right decision in buying MITSUBA!
View detail
Prepare for accidents and aggressive driving.
I used to use Daytona's monocular ActionCamera and DVR, but it finally broke after several years of use, so I replaced it with this one. The instruction manual is very well written, and I can check the settings and images on my smartphone. I chose front and rear type and pushed the body into Seat CowlRear. 128G card is high durability type. View detail
Old Type, but enough!
The new model is more waterproof, but if you install it properly and are careful when washing the car, the old model is fine and the image is beautiful.
The drawbacks are that the connection with SMA Four Pre cannot be made unless the connection is made with the in-flight mode, and the download of the image data takes longer than expected.
View detail
Fits: KAWASAKI Ninja250, KAWASAKI Ninja400
Drareco pedestal
Designed to fit the car model, Bolt On and installation is complete!
However, since the Front is matched to OEMMirror, it was replaced with ThirdParty product, so a little ingenuity was required for Camera installation.
View detail
Be prepared for anything.
[How is it used?
I installed it about a year ago because I didn't know what would happen.
Was the one you received as per Image?
The body is larger than expected and the wiring is thicker than expected, so it may be difficult to install depending on the type of car.
How was your experience with it?
I am satisfied with the Beauty of the image. Battery seems to go up because it takes a long time to upload to the app.
[Points to note]
In my case, I mounted it on top of the Front Fender, but when the Fork sinks, the Camera hits it.
How did it compare to other products?
Relatively Compact and seems to perform well?
Other items that would be helpful
Items to buy together
Number Bracket
View detail
Impeccable product!
GunGun tightened without cracking or chipping, and it doesn't even shake when dropped on the ground! It's just tough!
You won't find a better mount than this! It's a RECOMMENDATION!
View detail
Great build! Sturdy!!!!!!! But you have to get your own Rubber or you will Gap!!!!
As the title says. The build quality is great, but you have to prepare the rubber yourself (it deteriorates over time and must be replaced every year).
Gap falls off fast if you don't wrap it lol I wish it came with Rubber… The build quality is great!
View detail
A little too high.
It is an OEM Product, so it is perfect, but not cosmetically pleasing.
The paint job is also not good.
View detail
Note the size
Tail lamp was in the way and could not be attached. Please consider carefully before you buy. 1.5cm height plus Camera is needed on the Number. View detail
SizeSmallest
I installed the bolt on the front fork, which is supposed to support up to 54mm, but I think it is difficult to use the supplied bolt. I prepared a longer bolt and managed to install it by bending the receiving part. The quality is not good for the price, and the paint is also scratched.
It will probably rust after a while.
View detail
Thickness of the plate and good paint job
I installed it on my CRM250AR. Fitting is perfect. View detail
hmm
I guess it can't be helped because it is a combination product, but the pitch of the Bolt where the Number is mounted does not match. Also, in the case of ZX12R, depending on the angle of the Fender Eliminator, the camera mounting part may hit the rear cowl and there will be no space for the camera to be mounted. I had to cut here and there, so I painted it. View detail
I thought it was made in Japan, but it was CHINA.
I have owned 3 motorcycles and just bought a new 250 Motorcycle, so I decided to go with Mistuba! (Large type and 400 medium size are made by Aquillo) I didn't look at the box carefully, so I looked at the unit after installation and saw that it was made by Inch China. It was a bit shocking, but it is a JapanBrand and I think the quality is good. First of all, the motorcycle I bought this time is YZF-R25, so there was not much space under the seat. This Mistuba unit is large in width but not thick, so I think it is easy to store. (Acuyo's Unit is about two Mistuba's worth, so it is a little thicker.) Wiring is very easy. I used Scotch 3M Tape for car exterior because the double-sided tape that comes with the camera is not very adhesive and may peel off. The response to IgnitionOn is fast and the quality seems to be good even though it is from CHINA. I always think that when I install a Motorcycle camera, whether it is Acuyo or Mistuba, the Wiring from Unit is too long. What is wrong with long wiring is that if you leave it as it is, the wiring gets messy and dirty under the seat, so you have to tie the cord together with a tie band. Even if you put it all together, the wiring is still long, so you have to use Emon's Relay1.Quantity:It takes a little Space for about 5pcs. To install the result, you will need to use the DrarecoUnit+Wiring Summary×Quantity:2pc. Since space for a set is required, it may be difficult to install for those who ride a large type SUPER SPORTS750, etc., which do not have enough room under the seat. My YZF-R25 was neatly put together using D-UNIT, and it seems to fit under the Seat in the Limit. I think it is good to be able to view the recordings on my phone, but I don't really know how to use a phone, so I would like to see an app that makes it easier to understand. I would like you to make the app easier to understand. However, Mistuba is the only company that I can trust for the quality of the DVR, so if I buy a DVR for my motorcycle, it will be Mistuba's product by all means. I didn't know that Mistuba's DVR was available and bought a Chinese AQUILLO DVR for about 24,000 yen, which was a waste of money. It would have been a disaster if I had an accident and it didn't capture the incident, and I'm afraid that the Acuyo would break while I'm using it. View detail
You can mount a posterior CAM on Simple!
There are several companies that sell brackets for mounting posterior CAMs, but we chose Mistuba Sankowa's because they have even the screws in black, and the equipment is simple and does not look like it was installed after the fact.
Compared to the Type, which places the CAM on a pedestal, I was concerned about whether the orientation of the CAM would change due to vibration, but so far it is working without any problems.
View detail