Reviews
Fits: KAWASAKI ZEPHYR750, KAWASAKI ZEPHYR750
THE detail that does it all.
A piece can be seen, a change without really noticeable effect. but a more qualitative visual on the kawasaki 750 Zéphyr. -------------------------------------------------- -------- A room can see, a change without really significant effect. But a more qualitative visual on the Kawasaki 750 Zephyr. Powered by Google Translator View detail
na metal craft torque rod
pure quality , perfect fit and sits nice next to the gold caliper , very high quality , and will never rust great , brembo calipers are next on the bucket list , then ohlin rears View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
From OEM
Replaced a RustRust OEM. no worries about Rust as it is Stainless and the width fits fine so I am happy with it. View detail
To make MONKEY a 14-Inch
Used to change MONKEY's rear wheel from 8Inch to 14Inch It was
The rear wheel used is a LITTLE CUB
MONKEY's Rear brake has a structure where the DrumPlate fits into the swing arm groove But the Rear brake and DrumPlate from SUPER CUB and LITTLE CUB are The Swing Arm and the Torque Rod are used to hold it in place
Therefore, in order to put a LITTLE CUB REAR wheel on MONKEY, you must have You will need to accept the Torque rod
If you have a welding machine, you can weld the Mount to the Swing Arm in a freaky way, but I don't have one, so I decided to mount floating
Probably Repair Parts of some kind
I found it by accident and it was quite nice
Of course, it can't be said to be unprocessed in order to put in the Wheel, but Swing ArmLeft Because it only extends the Axle Shaft hole of the Side, if you have a Leutor or electric drill, you can use it It's manageable
The Swing Arm width was the same, so even if you remove the unique wheel of the SUPER CUB, the hub is still the same We were also able to make use of a structure that doesn't fall off
I've let go of the MONKEY I made now, but I may make it again, so I'll be a little more I hope you keep selling them
View detail
good
I used it on my Z series Rear
I wanted to mount the Caliper to the underside, and even more so, I wanted to make it a rigid mount I was looking for a short size Torque rod
With the shortest cooking, the distance between the center of the hole and the center of the hole was approximately 270mm, so Caliper's position is now just below us
I'm very happy with the position I've found myself in
I chose Silver and the Design is perfect
View detail
It changed, when exchanging the Webike Monitor Swing arm and a Wheel. rigidity and brightness do not accumulate. Mr. OVER, the highest.
It changed, when exchanging the Webike Monitor
Swing arm and a Wheel.
rigidity and brightness do not accumulate.
Mr.
OVER, the highest.
View detail