Reviews
Fits: KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA, KAWASAKI ESTRELLA
Single-cylinder Engines are also susceptible to cracking.
I was wondering if I should replace the Lens of the Tail lamp with an external Tail lamp unit, or keep the OEM unit and just replace the Lens.
If you think about it... Tail lamps have a strong attachment element these days due to the influence of customization, but they are security parts, aren't they?
You need to know the implications about Tail lamps.
Motorcycle Tail lamp
The primary purpose of the tail lamp on a motorcycle is to let the following vehicle know that the vehicle is moving. 。 Lamps also provide an indication of the distance to be measured by following vehicles. 。 The Brake light is activated in conjunction with the Brake applied by MotorcycleRider. 。 It is used to notify people that the vehicle is decelerating and also to let them know that the vehicle is stopped.
So the purpose of the →stop-lamp and the lights for night driving?
Stop-lamp (braking light) Stop-lamp is a light that is turned on when brake is applied, and is also called stop lamp or braking light.
And there are standards.
[Criteria
(2) The light shall be visible in daylight from a distance of 100 m behind it, and its beams shall not obstruct other traffic. 。 The light source is 15W or more but less than 60W and the Large size of the lighting part is 20cm2 or more.
As a security standard*. Red color." be, The light must be visible at night from a distance of 300 meters behind, and the light source must be between 5 watts and 30 watts." etc.
→security standards = also applies to vehicle inspections.
Red color
‥ [Color] In the case that Smoke is attached, the security standard of the vehicle inspection is [Color] If it is Clear, it will pass the inspection without any problem. 。 Security Standards. [Color] Clearable. [Color] When applying Smoke, thin [Color] You will only be able to put up Smoke No. 。 When the Tail lamp is Clear Lens, the color of the Lamp should also be noted.
→ especially the color of the bulbs is a problem.
Where should I install a Motorcycle Tail Lamp? ]
Tail lamps are installed in the center of the car body inside of the blinker, and if there is more than one, they are installed in the quantity.:Pair (for Left and Right) Must be mounted symmetrically 。 In addition, Motorcycles that require vehicle inspections must be very careful when replacing side numbers because the standards for vehicle inspections are very detailed and even a small amount of gap may not pass inspection.
Based on the above, I would like to know if I should use an external or OEM tail lamp. I am wondering...,
OEM→ No worries.
The color and illumination of external &arrarr;lights should also be carefully examined.
This means that.
In the end, I decided to replace the Lens Only because I don't dislike the OEM design. It's cheaper and there is no problem with the safety standards.
How to exchange
Remove the Screw holding the Lens of the Tail lamp.
↓
There is a *Gasket between the Tail lampBody and Lens. Remove it as well.
*Don't forget that Gasket is water leak prevention.
↓
New Lens, Gasket in between and screwed in place. 。
What is good about OEMTail lamps,
The large size of the car makes it visible to other cars.
Fat units, as well as Lens and Gasket, can be ordered individually, so they can be used for a long time.
There is no doubt about the Fat Security Standard.
One drawback is that it is a single cylinder Engine, so it cracks under vibration (laughs).
View detail
Fits: KAWASAKI BALIUS, KAWASAKI BALIUS, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI BALIUS-II, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR, KAWASAKI ELIMINATOR
Genuine Kawasaki Lens for Eliminator 250V 2007
A bike came in and needed some attention. One of the main thing that struck me was the busted tial light lens. I did try and find this part locally but no one actually had it or said they could get it. So, I was very pleased to find that Webike could source this part for me. With a few other parts, all shipped by EMS and delivered to my door in 100% perfect condition in 5 days. The lens was wrapped really well so not to get any damage on it. It is a really cool retro piece for this bike and looks crisp and clean. The colours are immaculate and crystal clear. Even the clear bottom is superb. The fixing holes are nice and fresh, no weird shapes so the bolts fit in perfectly. I was a little cautious that this would make the rest of the bike look dated but I was totally wrong. It looks cracking now. Brillianit job guys, thank you Webike for the services you provide. View detail