- Home
- Product reviews
- Search reviews
Reviews
PCX125JK05
Front suspension of PCX125JK05 is Quantity:Pair (for Left and Right) The size or rather the shape is different in
So Quantity:Pair (for Left and Right) I don't remember which one, but it doesn't go on straight away, so a lot of ingenuity is required.
It was scratched or the paint peeled off.
Rubber sheets for protection, such as double-sided tape, should also be prepared.
I have no problem with the sturdiness of the product or anything like that.
It would be nice if there was a dedicated Bracket, but there is not.
I wonder if it will be attached if Type is made into 44 pie.
View detail
Durability concerns?
Used in CUB press 50.
It is very bright due to the fact that it is LED. When I first bought it, I thought it was a very good buy.
However, about two weeks after purchase, it finally stopped lighting up with symptoms like poor contact.
I'm wondering if the vibration caused the damage.
I purchased the LEDs with the expectation that they would last for a long time, but they stopped working in a shorter period of time than expected.
I can say that it would have been a good purchase if it had been used for a long time, but the period of use was too short to say it was good.
I think the price is not very cheap product, so I expect improvement in durability.
View detail
It looks exquisitely fake.
I don't expect much from the price, but it is what it is. If it breaks, that's all there is to it. View detail
Beware of mounting bolts!
Comparing with the LED fog of KITACO, I think that there is no large difference in shape and performance, and I think that there is a little bit less expensive LED fog I bought this Lamp
However, when trying to tighten the Bracket mounting bolts during installation, the M10 Can't slip and tighten with Spanner or Glasses, and the M9 tool won't fit?
When measured with Caliper, it was a whopping 9.5mm square Bolt and Nut
I don't have a tool of that size, so I ended up with an M10 Stainless bolt and Nut I bought the
In addition, the part of the body uses the Cap bolt of M3 I was about to lick it with Bolt, so I replaced it too
In the end, it might have been less expensive to buy a KITACO Lamp
I have no complaints about the key Lamp performance
View detail