Reviews
Fits: YAMAHA YZ125, YAMAHA YZ125X, YAMAHA YZ250, YAMAHA YZ250X, YAMAHA WR250F, YAMAHA WR450F, YAMAHA YZ250F, YAMAHA YZ450F
Free from tipping trouble by using front and rear simultaneously
I was confused between Slider and Axle Shaft, but I chose this Parts which has Repair Parts for Slider.
By the way, Slider seems to be common before and after.
It is mainly used on AsFast.
I think it is better not to use it in Off-road because it seems to be easy to be caught in reverse when falling.
It has been tipped over many times, but there has been no damage or dislodgement due to tipping, which was a concern, and from the wear on the Slider, it still looks usable.
I also use ZETA Armor HandguardPRO (Side mount) and DRC Motard Footpeg, and with this combination, I have almost no damage by fall.
It also protects relatively expensive parts such as Brake Caliper and MASTER in the front.
Of course there is wear and tear on the slider due to falls, but this and all other parts have a RepairSlider setting so you can replace it at any time.
There is nothing difficult to install, but you will need a high strength 9.5sq LongExtension to tighten the Slider that replaces the OEMAxle Nut on the Front Left Side.
I think that the one that is too thick cannot pass through the hole of Slider and cannot be used.
It should be about 50mm long, reasonably thin, and able to withstand a tightening torque of about 60-90N, so be careful when purchasing.
View detail
Fits: YAMAHA YZ125, YAMAHA YZ125X, YAMAHA YZ250, YAMAHA YZ250X, YAMAHA YZ450FX, YAMAHA WR250F, YAMAHA WR450F, YAMAHA YZ250F, YAMAHA YZ250FX, YAMAHA YZ450F
To protect the Axle Nut
I bought this because when I competed in a Race, I fell and skied about 10Meter and the Axle Nut was shaved off.
If the Nut and Shaft are shaved, in the worst case, the Screw mountain will be crushed and the Nut will not be able to turn.
Installation is a simple replacement for the OEM Chain Adjuster.
The size is almost the same as the OEM Product, and I did not feel any inconvenience when adjusting the chain pull.
The shape is different on the Nut side and the other side, so the Adjuster's Line is viewed from the back.
The CNC Machining process is very accurate and the rattle is less than OEM Product.
I've had it for a few years now, and the slider is still working as shown in the picture.
Even if it is worn out, it is very nice that Slider only parts are set separately.
It glides moderately, so there is less tipping stress around the Handlebar and footpeg due to strange hooks.
I use it in conjunction with ZETA's Armor Handguard PRO and DRC's footpeg with Slider, and the damage from falls is almost gone.
Before installation, I was worried about the damage to the Bolt that holds the Slider resin, but the Large seems to be surprisingly strong.
I'm embarrassed to say that I retightened it for the first time the other day, and I didn't notice any loosening or bending of the Bolt.
The strength is phenomenal.
The appearance is worn out and the slider is worn out, but it is very sturdy and Repair Parts are set up.
I think it's one of those products that you can use for a long time.
View detail