Reviews
I think it will look and function better.
[How is it used?
Only city driving and day-touring.
I was curious about the Side Stand, which has a simple structure compared to the body of the car.
Purchased
Was the one you received as per Image?
It was as luxurious as the Image or even more so.
The detailed finish is so beautiful that it is almost a shame to use it.
Was the installation difficult?
Maintenance Standetc., if you have something that can Lift the body of the vehicle.
It is easy. If necessary, screw lock materials are available.
How was your experience with it?
The body of the car didn't change much in its wake.
The Side Stand will not stop rolling into the gravel.
[Included Parts:were they on?
Only Screws and a simple Instruction Manual were needed for fixing.
The Manufacturer is a good feeling Manufacturer, packed in a solid box.
View detail
It is safe.
[How is it used?
I installed it the other day.
Was the one you received as per Image?
Yes. Just like the picture.
Was the installation difficult?
It is easy to raise it with Rear stand and fix it with Hexagonal Wrench in accordance with STAND.
How was your experience with it?
It increases stability and is easy to stop even on gravel.
[Included Parts:were they on?
Body、Screw、Instruction Manual
[Was there anything that disappointed you?
Just a little hit will scratch it and make it a little more noticeable.
View detail
wedging oneself in
Dress-up and counteracts the softening of the Asphalt under the hot sun and the ground that is easy to sink into.
I was very pleased with the color.
If you have two people, one to raise the car and one to install, it is easy to install.
View detail
Cost performance?
I think the original Stand End part is also quite wide, but I bought it for more stability I did
As a manufacturer in Taiwan, I was a little anxious, but it was not that complicated It's not Parts, so I was able to put it on quickly and easily
It is important to note that the body is aluminum and the attached Bolt is also It's aluminum, so if you tighten it too much, it will break in a flash
The red color is also a nice touch
But is it still too expensive? I think so
View detail
Good in cost, good in design, poor in function
Cost and design are good, but when you try to install it, you'll see that the tip of the STAND is It got stuck and the tip bolt of the Stand End could not be attached As a result, it is fixed hard with two rear bolts It is running in the state of worrying that it will fall off at any moment
View detail
High accuracy and stability at the time of grounding has been increased
This Redea Stand End is more accurate than the other Manufacturer's that I have used before is high, and the clearance between the STAND base and the surface to be fixed is tight It is no longer necessary to bite the ground Also, there is a ditch on the back of the end for drainage, but this will prevent it from biting the ground I think we're doing well
Installation is just a Hexagonal Wrench with bolts to hold the washer in place But there is no rattling
The S750 is built on the bottom of the STAND I took a gold mallet and mashed up some pipes at random I think this kind of Stand End is a necessity for safety It is a good choice I chose Black, which is less noticeable to me, but the construction is good, so even if it's in other colors, it's not too subtle It could be a CustomPoint
View detail
It didn't work
use it for the Short Side Stand of ninja250 KIJIMA's Lowdown Kit When I tried to use it, I couldn't use it because the leg of SIDE was too small
View detail
Try to install it
I installed it in TMAX 530 DX in 2007. The ground area became Large, and the sense of stability increased in places such as earth.
In the wearing picture, it was from the front, but there was no picture from the rear side, but I could not understand, but the tip of the presser foot floats a little.
I think that it is better to use glue on the Screw fastening part. Also, sometimes it is necessary to confirm that it is not loose.
View detail
Sitting sensation Imaichi
I changed from S1000XR to S1000R. I used Dimotiv when I was in front..
I could stop by just Screw and I was worried about falling. Because this item will attach Cover
I thought it looks relieved and purchased. Black Cover is slightly floating and the feeling of sitting is not good.
Reliability when stopping to loose ground, neither item is no problem.
I think that it is a problem of the BMW side.
View detail