Reviews
Dullness Solution
Rubber is just right because it was tacky. It can be installed by anyone right away. 。 If you think Rubber is lame, by all means. View detail
Good vibes
I was really not satisfied with the OEM rubber cap, so after installing it, I am Large satisfied. View detail
Because OEMCover is not cool.
I bought this because the OEM Cover is not good looking, and I was worried about the Rear Axle guard, but at the time of purchase, I was considering an external exhaust system, and there was a possibility that it would interfere with some of the exhaust systems, so I decided to go for the easy way out.
The design is much cooler than OEM. Personally, I think it would have been nice to have a product without the word "Manufacturer" or with a simple design.
Also, the cover itself is reasonably stiff, so I think it will protect the Swing Arm if the fall is just a standing fall.
As others have said, the space between the pins is too narrow to fit easily, and since I didn't have a plastic hammer, I couldn't knock it in, so I widened the pins a bit.
Also, due to the trial and error process, the grooves were scratched quite a bit by the pin, and the pin's clamping side (the side that goes out) was sharp, though not sharp, so it scratched quite deeply.
When I wiped it with Plexus, it became less noticeable, but when I left it as it was, it stood out as Large, so I think I need to be careful when installing it.
View detail
It's not bad, but the cosmetic?
It is the same color as the Front Axle Slider and the balance can be taken, and it is not bad, but I think the price is high. If it is half price at least, I think it is a bargain.
Is the Material penalized, or is it just enough to Cover you if you have a light standing gouge?
I don't think it's a replacement for Slider.
Well, Slider will be replaced if it falls, too, but it is Style outstanding compared with Rubber cover of NORMAL.
Installation is very easy, just remove the NORMALRubber cover, pull out the Split Pin, put it on and insert the Pin.
View detail
It's not half as luxurious as it sounds!
The cap is well machined so the Snap pin is a little tight but it stays in place. It's a lot more expensive than the OEM Rubber cover. This is a great product.
Material:I think PlasticCap can be expected to serve as a slider in case of a fall.
However, I think this price is still too high just for the Cap and Snap pin.
View detail
This is exactly the Parts I wanted.
The Z900RS must prepare the split pin when adjusting the chain.
I was looking for a Beta pin that is both fashionable and easy to maintain, and this is exactly what I bought it for.
I'm very happy with the accuracy of the NutCover, and the Pin is not a waste of time.
I dare to say that the drawback is that the price is too high and the end surface of the Pin is poorly finished and does not slide in comfortably as it is.:It's Stainless Steel, but the color is not good, so I polished the edge surface to be smooth, and the PinBody is also polished to Polished (although you can hardly see it)
I feel the mark printed on the cap is noisy personally, but it is bearable. However, because the position of the hole and the print are not matched, when you want to adjust the position of the mark, you need to adjust the position of the Axle Shaft.
It takes a certain amount of effort to pull out the pin, so I think it won't come off while driving or get tricked on the road, but I fixed the wire with insurance.
View detail