Reviews
Good Very good
Very good Very good Very good Very good Very good Very good Very good Very good Very good Very good Very good Very good Very good Very good View detail
Very Very good
Very good Very good Very good Very good Very good Very good View detail
use as a replacement
When I was running a mountain before, the car fell down and the original tie rod of the wind speed clutch was worn out and deformed so that it can no longer be used. Fortunately, it didn’t hurt the body. Spend very little money to buy a replacement tie rod and replace it with normal use ------------------------------ ---------------------------- When I ran the mountain before, the car poured the car that caused the wind speed clutch to wear deformation. It was not available. Fortunately, the clutch that did not hurt the wind speed of the body was very strong. Even if the lever encountered a fall, it would only wear or bend. Spend little money to buy one lever and replace it with it .It can be used normally. Powered by Google Translator View detail
Finger Quantity:Recommended for those who pull Clutch with 2pc … but
So far the Clutch operation has been performed with the finger Quantity:I was pulling with 2pc, so when I replaced it with Gail's Wire Clutch Holder, I converted it to Short lever.
Basically, there is no dissatisfaction with the Clutch operation and the finger Quantity:For those who have been pulling in 2pc, this is the best choice with no problems.
However, this time we changed the clutch holder to a variable ratio clutch holder to solve the weight of the clutch by installing an external slipper clutch, and changed the ratio from OEM 34mm to 32mm. The result was that the weight of the clutch was reduced to the original weight.
It is obvious if you think about it calmly, but I wonder if short lever will not break lever even if it falls down... or basic finger Quantity:I thought it would not be a problem since it is a 2pc, but when I ride long distances, such as touring, I feel fatigue accumulating and at the end I was pulling the short lever with three fingers;
Of course, it is ridden on a daily basis and finger Quantity:I have no problem with 2pc people, but I have not been touring for a long time and it was hard for me due to lack of muscle strength from not being able to ride normally, so I have returned to standard lever for now.
I think I will keep it as a Stock until the Standard lever breaks off if it falls over or something.
View detail
Short leveraging
I bought this to shorten the lever of GALE SPEED's elabo RateBrake master.
It is a good make of Lever. There is no Large difference in thickness, etc. from the originally attached Lever.
It is the best grip I have ever had. I had not thought of making a short lever until now, but I had a chance to touch it once, and the feeling was so good that I decided to incorporate it into my own machine.
I think it depends on the individual, but Brake the finger Quantity:Those who are hanging 2pcs are Recommendation.
Compared to the length of Standard's Lever, I think it can be controlled more delicately.
I feel that this is a cosmetically superior customization of Brake that can be done for about 5,000 yen.
View detail
If you could just give me a choice...
I installed the VRC φ17.5 on my MT-09, but the standard RoundLever contacted the Accelerator WireBox, so I replaced it with this Standard Type.
I hope you can choose the Type of Lever because I like the shape of this one better.
View detail