Reviews
The non-gussied up design is GOOD!
The Grab Bar by DAYTONA that I had been using up to now was not so bad, but I was concerned about the gills of the Fender Eliminator, so I replaced it with this one, which is a less protruding design. I was concerned about the gills, so I replaced them with this one, which has a design that does not stick out too much.
The sleek and clean design is perfect for the Fender Eliminator Motorcycle, and I am very satisfied with the large size.
It's easy to grab and go, and the performance is fine! Now if only it were a little cheaper.
View detail
Grab Bar G-Craft
I was torn between the Grab Bar and the Rear Carrier, but I chose the Grab Bar for its frequency of use and appearance. I think it is a matter of taste, but since the area around the tail lamp of MONKEY is plated, I wondered whether I should match it with plating or put it together with black refreshments. As a result, the black of the frame and the texture of the grab bar were close, so I think it was a good choice. 。 I thought it would be easy to install, but I had to shift the Rear Fender a bit before I could install it. Also, there is not much clearance with the Rear blinker, so I had to work while fine-tuning. Initially, the Right Side blinker was in contact with the Rear blinker.:Pair (for Left and Right) The difference in Clearance is due to the bolt nut included in the kit. I put a black bolt nut in the opposite direction of the instruction manual because it looked bad. I will observe the progress and be careful of the Clearance. It is a long story, but you will need a tool such as Hexagonal Wrench or Glasses Wrench to install it. Be careful not to lick it, as it is hard and tight! View detail
Cool
I'm not sure if I'd like it if it was a little taller. View detail