Reviews
Fits: KAWASAKI Ninja ZX-636, KAWASAKI Ninja ZX-6R
A little modification is needed to attach the Heat Guard!
Installed on a 2022 ZX6R. The middle pipe itself is easy to install, the OEM exhaust pipe side is installed with a liquid gasket since the OEM gasket will not fit. The silencer side is exacty with the OEM gasket. The bracket to be installed on the body is also without modification and fits with the OEM bolt, but no nut is included.
The problem is that the Heat Guard does not go on as is. The bottom two bolts fit, but the bracket that holds the guard on the top side has a gap of about 1cm on the front side, so I bent the bracket with pliers and installed it.
Sound became louder below 6000.
View detail
Fits: KAWASAKI Ninja ZX-636, KAWASAKI Ninja ZX-6R
Fair enough; quieter than M4GP.
It is on 21MODEL.
The sound from Idling to 7000 RPM is fatter than the OEM lunchbox.
After 7000 RPM, it may be LARGE and the same as the OEM lunchbox? It seems quieter than when I had a straight M4GP tube.
As for the sound change, the characteristics of the Titaniumium silencer seem to have been emphasized more. (More dry high frequencies are emphasized)
As for the sound, I am satisfied.
However, the Bolt hole position on the Heat Guard did not match, as is to be expected since it is made overseas.
We had no choice but to bend the Heat Guard by force to fit the position and set it.
Also, there is no Bolt nut to hold the Exhaust Bracket, so I purchased one at Home center.
Also, both in-outs are thicker in diameter and quite Tight.
It was necessary to slightly widen the exhaust pipe connection with Pliers.
The positional relationship with the exhaust pipe and silencer is the same as OEM, so we are happy to hear that they are perfectly aligned.
Good appearance as it is clean and polished. Welds are messy but clean.
Overall, I can recommend it.
View detail
subtle
Because the installation pitch is not suitable, it is a little bit large, and when I put the Cell Keto Exhaust System of SCORPION together, the installation of the Exhaust System is also about 20mm short.
I put it on for some reason, but I will never buy it again.
View detail
Pay attention to the volume and sound quality
It's going to be a hell of a lot louder
Use it in an environment where there are no volume restrictions
If you don't mind the sound, these items are inexpensive and lightweight
I tried Inner baffle etc. for Normal silencer, but the volume and output characteristics were not good could not be made to a satisfactory Level If you are thinking of removing the catalyst and sound deadening at the same time, you should install the Full Exhaust System Recommendation
Quantity of Pipe:Pair (for Left and Right) The gap between the two was a few millimeters too narrow, and we were finally able to insert it while holding it down with two people It looked more like a design error than a bad accuracy
View detail