Reviews
Round Position?
Height 172 cm. Inseam Ordinary? Winter Over Pants It is useful because it does not slip when using Pants. Also, I think Riki should be able to do Knee grip first! It will be useful at full acceleration or full Breaking! View detail
Fits: YAMAHA MT-125
It works.
I tried installing because I slide with Knee grip at Brake and Cornering.
You can feel it as soon as you run.
It may be a difficulty to take the delivery date too much (I waited for two months or more. )
View detail
Expected as expected
The effect we had anticipated before installation was expecting the TankGrip effect to be able to ride even with Nylon's Over Pants and ordinary Pants.
The result was as expected and Over Pants was able to get the same feeling of grip as Leather pants. There is something more than I expected.. It can be recommended more than enough.
I thought that the installation is "feeling", so I felt it is best to take a closer look. The Instruction Manual also supports five languages, but there is no description in the translation (please enter here.
Wa Big's item description has a video and explanation, so let's see that one.
View detail
The best performance I've ever used
I tried various Manufacturer's in R1 of 10 years but purchased Repeat because it got peeled off and I got on Eazi-Grip with weak Grip power.
good point
Grip force, full Brake will slip by any other company's products, but with Eazi-Grip there is enough Grip ability to hold firmly
Sticky Tape is quite powerful, once it gets stabilized once it gets sturdy
Largeness of unevenness, quite small It is not conspicuous without a feeling of warts and there is almost no Damage in leather bread
A bad point
When the adhesive tape is too strong and it is hot, it peels off with the adhesive layer when peeling the backing paper
Translate to Instruction Manual (Please enter here as well, do not have pictures or Illustration, you have to find while striking where to put each Parts Fitting
Because it is made overseas, there is no stock and I waited close to one month
General review
Since Tank Pad is attached and it interferes, I installed it with Scissors Cut.
People who do not have confidence are better off leaving to Shop because paste is exclusive of some manufacturers except for Manufacturer
View detail
Fits: HONDA NC700X
I think it's good.
I used it for 2014 MODEL of NC 750X, I used Black because the air bleeding seems to be Large, I cleaned the surface firmly and warmed it with Dryer and worked carefully because the Side cover part is satin finish I have used it for over half a year because I did it, but there is no peeling.
Although it smells, it smells pretty much when opening it, but it will not smell any more once it sticks.
View detail
Fits: KTM 390 DUKE , KTM 200 DUKE , KTM 125 DUKE
Grip it moderately
I feel good, I feel that the sense of stability during Riding has increased.
I also match the texture of the retrofitted KTMErgo Seat.
However, I was lost for a moment as to where to paste as a reference.
View detail
Exquisite position
We installed PROSeries of EasyGrip on GSX-S1000F.
In 690 DUKE, we added transparent EVOSeries so we selected PROSeries this time.
In Riding, GSX-S often holds the Fairing section at the bottom of the Tank rather than Tank.
OEM's Fairing was originally treated as a nonslip, but it was a process to the extent that it would not grip at all with Denim Material.
EasyGrip is made up of Seat of Tank Parts and Seat of Fairing part and the position of Seat of its Fairing part is exquisitely exquisite. When crossing the Motorcycle, it is easy to hold the Motorcycle naturally.
I selected Black this time, but the advantage of Black is not conspicuous even if air enters inside Seat, and like a person I am just fine to human for Large roughness. In the case of transparent Seat, we stuck carefully so that no air enters.
Because GSX-S is Frame also Black, in that sense it was a black sticker that the color was tightened and it felt good.
View detail
Fits: TRIUMPH DAYTONA 675 , TRIUMPH STREET TRIPLE
There is effect!
Because I often ride with G-bread, purchase with expectation of assistance of Grip. Of course there was no setting in the old car, but for Triumph I thought that the degree of freedom to paste it is divided into three, when I arrived at the original bad, Limit fitted. Grip power is just good feeling, it works only when firmly griping Knee.
When it is riding with Lady, it is not so obstructive. This area is good. Since you can cut freely with scissors, as long as the Large body Large is fitted, you can use old cars without settings, and it is easy to paste and peel off.
View detail
14 year model GSX1300R HAYABUSA
Quantity : Pair (for Left and Right) It is difficult to paste it symmetrically, but Seal, so the work itself is simple.
The effect is much better for Knee grip's grip feel.
However, there are not holes in the picture of product description.
What on earth are they?
View detail
Fits: TRIUMPH DAYTONA 675 , TRIUMPH STREET TRIPLE
I need hang to work
Since the protection color Seat is stretched on the adhesive surface, it is easy to misunderstand because it does not look like Clear in the reaching state.
Clear type requires careful work for pasting. Since the adhesive surface is visible, careful removal of air bubbles or the like from the edge will result in poor appearance. Bubbles are easy to pull out when working to press it with your fingers little by little from the edge.
As I saw in the previous impression, it is certain that there is a cut-off feeling at the end, but it was not enough to care. There is something that you purchased on this premise that you cut this side by using other types of cars and using it. It would be better to avoid people who care about details.
Performance (Grip feeling) I just sat on Seat but I felt that it was right..
I thought about whether EPO solution was something because Tsubutubu was Large, but when I tried to paste it did not make me feel so strange.
However, it depends on the shape and color of Tank, so it is better to consider Large size and shape of Tsubu firmly.
View detail
Please accompany Knee grip
◦ 【What made you decide the purchase?】
Previously, its power when riding YZF-R6 (At Stomp Grip) Because I experienced.
Purchase this product for what other Manufacturer thinks.
◦ 【How was it actually used?】
It had enough functions and there was no problem with use. There was no peeling, etc..
◦ 【Was it difficult to install? (Hard parts case)】
Since it is a sense to decide the position Quantity : Pair (for Left and Right) Gap is easy to occur. Also, bubbles may enter, it is quite difficult to stick cleanly with one shot.
◦ 【Please tell me the point of installation and hang (in the case of Hard parts)】
Since there is a movie pasted on You Tube, I referred it to it. The Instruction Manual can not be read in a foreign language ww
◦ [Is there anything I was disappointed about?]
It is not particularly. It was hard to stick it.
? 【Hope for Manufacturer】 - Please let me know if you have any improvement points]
Design is good, but Quantity : Pair (for Left and Right) There are two in each and it struggles to paste. I want a device that is easy to paste.
◦ 【Have you compared items?】
Stomp Grip.
◦ [Others]
Comprehensively it is a satisfactory product.
If you put it yourself
To perform degreasing.
Warm adhesive surface with Dryer.
Since it takes 24 hours for adhesion, do not put a load until then.
Is not it?.
View detail
I melted it with just one Circuit run
Since I used only this melted part in my short-legged, did the load concentrate?
Perhaps it was unfortunately a bad product, but since you do not know whether it is a defective item unless you paste and run it, it is impossible for you to return it any more at that time ,,,
View detail
It will not start without this.
SS tends to ride with arm arbitrarily by all means
Especially the Handlebar is also far from the TL 1000 R, and the movement performance in the city ride dramatically decreases by sticking his arms.
So I used the EasyGrip I used earlier. With a little power you can firmly Knee grip and you can support the upper body so Riding will be able to handle natural cornering without the power of the upper body.
Those who have never bought this item of goods, Recommendation to think that you are trying by thinking that you were deceived.
If you start running, you should know the reasons for Recommendation. Once you know it is a Recommendation that you want to attach to any Motorcycle.
View detail
Fits: KAWASAKI Ninja250, KAWASAKI NINJA300
It is this
2016 MODEL (2015 There is no change from late model. )
Since it seems that it cuts one piece from the Seat according to the shape of Tank, the edge feels like a sharp edge. It seems that it will come off as it has adhesive strength. However, it is unknown what will happen if you use it for a long time or change the Position of Knee grip several times. Considering Grip, I wanted not only the Tank section but also the resin section. Grip location has individual differences, so it's hard to say .... I wore it in the midwinter, but it warmed enough with home appliance Dryer and was easy to tension normally. Small technique to sprinkle soap water with misting is unnecessary. It is cheap as it is compared with other companies, and since Grip is done, it is this kind of thing when thinking with Total. People who want Grip at their desired position & who value emphasis on COSPA, it would be better to buy Universal Product and cut it out (I do not know the quality).
View detail
It is an essential item for SS.
I attached it to L4 of gsx-r1000.
With Breaking and Corner ring, you can hold down Motorcycle firmly. It is a necessity item for the forward leaning posture SS.
View detail
Fits: KAWASAKI ZX10R
Hold feeling of the lower body is good
There were many things that strange power entered into the bank in Corner, Tank and Seat in the bank, and the lower body was unstable with slurping. I wanted to resolve even a little I chose this Pad this time as a trial feeling.
Since there is no setting for VTR and Side cowl and Tank respectively, it is troubled by what type is good while watching a product image and when watching ZX - 10 R "This is it!" I decided by intuition..
Like an image
Pad stretched to Side cowl fits in a good feeling just by cutting a little extra place. Tank side also stretched to fit the knee when banked.
The difference was felt really when I tried after stretching, not only during the bank but also the body did not slide forward during Breaking.
Although the cut surface was coarse, I felt it seems to be premature, but because the cospara is also good, I will purchase it even if it peels off.
View detail
Grip power is good
I bought it because Corner had a feeling of knee slipping.
When I first saw the shape, "In what direction do you attach it - - - "Small I worried for an hour, but I think that it is probably wrong.
Grip power is enough. (Since I first attached it, I can not compare with other companies - - ) Knee grip Does not slide enough to surprise you. Just sometimes get stuck in reverse.
I think that it is good if the pass and the Curve should be stabilized even a little!
View detail
Fit perfect for your feet, making Riding fun!
I bought a popular TankGrip in the streets. I bought EasyGrip because it was cheaper than Stomp Grip. I bought it like a picture with a point that is colorless and transparent and Logo mark.
Type is PROType. Tsubuzubu is Small and fashionable Design. Even Jeans does not hurt at all, I can hold it firmly. Since there were four Z1000, I attached it to the knee, part that corresponds to peach like the image.
Effectiveness is outstanding! Foot and Tank are united, making it very easy to manipulate Motorcycle. Riding will be fun.
Since there is also another Black Type, the one attached to the Frame side may be cool even if it is Black.
View detail
Eazi-Grip タンクパッド
I pasted it on GSX-R1000 07. I usually ride with G-bread, I purchased with the inner thigh slipping in the bank and Knee grip strengthening when I am with the child and Tandem. In terms of size, well prepared, Hold also increased significantly. I could buy the price relatively cheaply and I am very satisfied..
I could paste without special consciousness, there is also no Damage in G pan. It is highly recommended.
View detail
Fits: KAWASAKI ZX10R
Attention to the curved surface
Purchased because it was somewhat cheaper than other Tank Pads
There is a commentary movie for installation, but it is very easy to install. It is safe also for beginners as it can do without imposing excessive repositioning
Feeling is Soft and I feel like rubbing even Denim fabrics for now. But I'm satisfied there because I can firmly hold it.
However, when attaching to the curved surface so as to be dented as a caveat, we recommend that you adhere Pad slightly to the curved surface as the curved part will float after a few days even if it is in close contact.
View detail