Reviews
Cosmetic! For protection of Axle Shaft.
[How is it used?
Used at Circuit. The screw thread of Axle Shaft was almost crushed when it fell down without being attached.
Was the one you received as per Image?
Yes.
Was the installation difficult?
Just pull out the SHAFT and insert the Cup between both SIDE.
However, if you assemble the Rear Shaft without thinking about it, as has been your habit, you will have to redo the whole thing.
You might want to get into the habit of putting Cup in the beginning.
How was your experience with it?
I haven't tipped it over yet, so I can't give an imprementation, but it is solid and secure for the low price.
The resin Cover is removed, but still high enough for Shaft protection.
[Included Parts:were they on?
It had parts to accommodate M10.
[Was there anything that disappointed you?
None
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
If I had to say so, I would say that the length of the resin slider could be a little shorter, as it seemed to hit the ground in the Circuit.
View detail
I can guard it well.
It is used for CYGNUS X2 model.
The Axle Shaft does not interfere with the ground on Scooters because the front fork is short and the cowl sticks out in a low position.
Since I had replaced the shaft with the Chromoly Axle Shaft from Other Brand Product, I had enough room to install the Axle Shaft Slider, but I think it is important to note that the length may not be enough for the OEMAxle Shaft.
When I used the thin nut supplied by another company, I sometimes licked the screw mount of the nut when I tightened it with the specified torque, so I did not use the supplied nut this time either.
When the mount base is installed, only the slider part can be replaced without having to remove everything.
Also, I think the Axle Shaft will be less likely to rust in the rain, etc. since it is completely sealed.
Since it has a shape that seems to have a high degree of universality, I think it can be used as a Frame Slider or Exhaust Guard in addition to the Axle Shaft Slider.
View detail
Installed on MAJESTYS.
UniversalAxle Slider installed. 。
I was worried that it would not be able to be installed properly because it is installed by inserting it, but it was large and strong. 。
The actual tightness of the installation is the Quantity:Pair (for Left and Right) Together, about 4.4? 。 If there is more room in the Axle Shaft, there will be no problem with installation. 。
MAJESTYS would have an extra turn and a half, so no problem.
Volume around the front is increased a little. 。
I scraped the bottom of my FrontCB400T when I was pushing and pulling the Limit near the wall, so I'm trying to prevent that!
View detail
Good size for 125CCScooter
I have installed it on PCX, NMAX and MAJESTYS
I have installed a similar product from another manufacturer before, but the outer diameter is Large I felt the balance is a little too big for the 125CCScooter
This Manufacturer is happy with the size that fits the balance of the look of the Balance just right! It is In addition, if you install it at the same time as the Rear Exhaust Guard, the Manufacturer will also be able to The shape is perfect to match
If only the resin Cap of GuardBody was a Repair item afterwards
If I ever get a scratch, I'll have to buy it from Assembly
View detail
To BW 'S 125 SEA 6 J
I inadvertently dropped the Tire and had a hard time restoring it
If you carefully work Large is strong.
What is the effect if you try rolling?.
View detail