Reviews
Lid is Large
There are various types of oil jugs, but I change the oil myself once or twice a year, so without a lid, I end up with dust and garbage all over the place.
So I purchased the lid because I felt it was absolutely necessary to have one.
However, the overall construction is still price-approved, so I am not sure if I would recommend it.
You might as well pay twice as much and buy a better jug. (The one that doesn't have a screw-in Type lid)
View detail
Just the right size
It is for 1 liter, so it is useful for refilling the Radiator with water.
It is easy to use because it is inexpensive and can measure quantities well.
The body size is also small, so it does not take up much storage space.
View detail
it is normal
It is a normal OilJack, but it is convenient because it has Memory. I think that it is a convenient commodity when there is it. View detail
From Scooters to Large Motorcycles
It's a little bit inconvenient because it doesn't have a fine scale, but it works fine. large size is easy to handle because large threshold jug is troublesome to wash and store. View detail
Buy at Oilfor Replacement in MONKEY
Because the amount of oil use is 900ml, I was looking for the one of the small size for 1? When storing, the tip of the hose and the spout also have a gap, and the place where the contamination of garbage etc. can be prevented is good, but because Oil does not fall from the Filter of the spout easily and the spout is slanted, Oil flows to the hose when measuring 900ml, and I felt that it was unexpectedly troublesome. I felt it.
If it's 900ml, I think it's easier to remove 100ml from the can and use Bellows to clean it.
View detail
For Gasoline Refueling
[How is it used?
I bought this for Gasoline refueling at Circuit.
I use it to calculate fuel consumption and to set the fuel to the smallest limit before the Race.
Was the one you received as per Image?
Image is correct, I use the same one for Oil.
How was your experience with it?
It has become the most recommended jug with lid and Cap at the end.
Garbage is hard to get mixed in, so the one I use with Oil won't get covered in dust and junk as long as I keep the lid tightly closed.
[Points to note]
When pouring, be careful not to close the mouth tightly or it will leak.
How did it compare to other products?
I recommend it with a lid and a Cap on the end to keep it clean and ready to use.
View detail
Expected
[How is it used?
I used it only once to change the engine oil.
Was the one you received as per Image?
It was smaller than I thought it would be.
How was your experience with it?
Until now, engine oil has been used in the lower part of the engine.
I had to adjust it while staring at it, but it was better to put it in after measuring it well.
It's convenient and gives you a different sense of security.
However, one thing that I thought I failed was that my Motorcycle, SB250, was
You need at least 1.2Liter when changing Oil, so you need to divide Oil into two times.
It's something you have to put in.
1.I should have bought a product that measures up to 5 liters...
[Points to note]
The lid is attached as an accessory, but it doesn't close that tightly.
Not to be used for spilling liquids.
Use it to prevent dust from getting in during storage. (Failure to do so)
How did it compare to other products?
This is my first purchase of Oil Jug, so I have nothing to compare it to.
1.If you have a 5Liter product, buy that one.
View detail
The capacity of the 250cc Motorcycle is just right.
[How is it used?
Oilfor Replacement
Was the one you received as per Image?
It was stronger than I thought.
How was your experience with it?
With a 250cc Motorcycle, the capacity is just right.
[Points to note]
If you have a four-cylinder, large type, it is smoother to buy the Oil Jug of large threshold size.
How did it compare to other products?
Cheap
View detail
If you want to change the oil.
【good point】
An easy-to-use 4-liter jug.
Motorcycle Oil is Large body and this size is just right.
[Bad point]
nothing special
[Summary]
If you use a jug when you change the oil, it will be less likely to spill and
You can manage the quantity properly, so if you often replace it yourself, you'll want to have it.
View detail
Convenient to have
It is used for both Oil and Coolantfor Replacement.
I appreciate the part of the lid that prevents foreign objects from getting into the storage area. I think it's easy to use.
View detail
I think it's good with no leaks
I've been using the cheap Oil Jug, but I couldn't stand it because it was leaking from the seams I bought this product as a replacement The feeling that I used it is not so bad It is a good idea to use 4 liters because it is a large capacity I think it's good and easy to use when changing the oil in the vehicle It also has a lid, which is a nice feature because it prevents foreign matter from entering the vehicle View detail
How do I clean it?
All of these things may be similar The spout of the Oil is Wide mouth and absolutely no spills There is a plastic mesh on the inside to prevent Garbage from getting in There is also a screw cap on the pour side, so you can leave your oil in and pour it out It is suitable for use as an add-on to a product
As for the feeling of use, it's not too much or too little However, I think it is the fate of this kind of jug, but I have to say that it is not a good idea to remove the oil from the container after use I have a problem with this Especially the Oil that got into the bellows is hard to find in KitchenPaperetc I can't wipe it off First of all, I used Parts cleaner in Jerzya to remove the oil When you leave it with oil on, you can use it immediately It's going to be gone
View detail
I guess that's about it
The CBR250RR (17’)
Used to fill with oil
The 1L scale is about right
2L is pretty much less than it actually is
CBR's Oil Mouth
Hose is thick and a bit
I spilled the oil
View detail
It's unstable in the sky
If it's empty, it's easy to fall over and unstable
It is uncomfortable if you have to roll over while working
I'm sure it would take this much Nozzle length to inject the oil, but the jug itself It is light and must be placed carefully or it will fall over
View detail
Large doubled as Small
Until now I put Oil in 2 L jugs in 2 times, but I gradually became troubled and purchased Large Yu jug so I can do it only once
Oil Jug also seems to be evolving, so Cap of the pouring spout has been changed, and what was connected by TagPin was formed as one piece. Thanks to that, it is easier to turn and easy to remove. The lid is unchanged and it is connected with TagPin
Although a net net is also attached, if the eyes were small or transferred Oil, it did not go down at all and it overflowed. We tried two kinds of viscosity of Oil, 10w-30 and 10w-40, but the results are the same
I put 4 liters of jugs of Oil and actually poured it, but it was heavy and I could infuse the last drop without being tired of arms. If you dare to give up the difficulty, since the pour spout is also getting bigger in proportion to the Large size of jug, it is hard to pour out a little if it is in Small Motorcycle
View detail
An Oil can be poured out ordinarily and there is not if a Nozzle breaks easily, a problem of being hard to see a Memory, either. It is a pure white jug which is truly featureless.
An Oil can be poured out ordinarily and there is not if a Nozzle breaks easily, a problem of being hard to see a Memory, either.
It is a pure white jug which is truly featureless.
View detail
It is an Oil Jug ordinary also also well bad. An Oil is moved from an oil can to this, and the oil is changed for a Motorcycle. although the scale reaches the place of 1 liter and 2 liters -- most vehicle types -- an oil amount -- being such --
It is an Oil Jug ordinary also also well bad.
An Oil is moved from an oil can to this, and the oil is changed for a Motorcycle.
although the scale reaches the place of
1 liter and 2 liters -- most vehicle types -- an oil amount -- being such -- I think that it will be more convenient if an every 100 cc scale sticks since it is not tight.
Also by
, I think that what is necessary is just this low price since what is necessary is just to put the mark on the place of the necessary quantity of its own Motorcycle by the Magic.
View detail
At the time of an oil change, since there are many 2.1L, 600 ml, and halfway things, it is utilizing. Since it pours and opening fits into lubrication opening exactly, it does not fall and is easy-to-use. Although a problem is a grade which is not
At the time of an oil change, since there are many 2.1L, 600 ml, and halfway things, it is utilizing.
Since it pours and opening fits into lubrication opening exactly, it does not fall and is easy-to-use.
Although a problem is a grade which is not, oil remains in the place of a bellows for a while.
View detail