Reviews
Used in conjunction with Under Guard
Right Side is the lower half of the ClutchCase Magnesium cover
Cover each of the following.
It prevents damage when falling on stones or hitting trees, and also protects against scratches and stains caused by Boots rubbing.
The generator side is perfectly protected by this alone, but the water pump on the clutch side does not have a cover, so it is possible to separate the water pump by using the Under Guard side to follow the water pump.
The back side has silicon rubber along the protective section.
The inside of the pack is unusually clean when removed after driving, as it serves as a shock absorber as well as for packing. However, after riding with Muddy, it is recommended to remove and wash them because of the mud that gets into them.
The attached screw is long enough to hold the device in place in three places, and it has never leaked even with oil in it, so it can be attached and removed by course.
Quantity:Pair (for Left and Right) Remember to tighten the cover tightly in advance, as 1 pc of each will be hidden under the cover.
View detail
Looks Yoshi for Defensive Up:??
It was guaranteed to fit up to 21MODEL, but I was able to pop it on my MY23 YZ250X.
The work is completed in a minute or two.
In addition to its defensive capabilities, the Engine waist looks tighter.
View detail
Fits: BETA X-TRAINER 300, BETA RR250 2T, BETA RR300 2T
For protection of Hit prone areas
When installing the Cover with the Under Guard, the Under Guard had to be removed once when installing the Cover, but it was easy to install. View detail
Fits: HUSQVARNA FX350, HUSQVARNA FE300, HUSQVARNA FE250, HUSQVARNA FC300, HUSQVARNA FC250, KTM 350XCF-W, KTM 350SX-F, KTM 350XC-F, KTM 350EXC-F, KTM 250XCF-W, KTM 250EXC-F, KTM 250SX-F, KTM 250XC-F
Sufficient protection for Clutch cover
To install, simply remove the 3 screws from the clutch cover and put it on the outside.
No oil or Gasket replacement is required.
It will be a little thicker, but once you get used to it, the overhang will not be uncomfortable.
I think it has given me more peace of mind since the goal is to control scraping and scratching by Boots and stones.
View detail
Fits: BETA X-TRAINER 300, BETA RR250 2T, BETA RR300 2T
Before cracking the Case.
Installation is easy and not difficult. It protects the Case from falls and stones. View detail
Fits: HUSQVARNA TC 250, HUSQVARNA TE 250, HUSQVARNA TE 300
Easy to install and easy to use?
Installation is super easy and even a maintenance beginner can install it right away. 。 Just installing it doubles the sense of security ^_^. View detail
Fits: HUSQVARNA TE 250, HUSQVARNA TE 300, KTM XC 300, KTM XC 250, KTM Freeride 250 R, KTM EXC 250, KTM EXC 300
The texture is better than the OEM.
The free ride is a replacement type for the OEM cover. View detail