Reviews
Fits: YAMAHA Cygnus X, YAMAHA BWS125, YAMAHA BWS125
When in doubt.
Used with CYGNUS2 model.
I wanted to raise the ride height from the OEM rear suspension to secure the bank angle, so I used the XMAX OEM suspension, but it gave me a strong feeling of being shattered and the cornering was unstable.
When I was looking for Other Brand Product's Rear Suspension, I chose this product because it is a suspension that is highly used by CYGNUS riders and it is also capable of overhaul.
Damping can be adjusted for both extension and compression, which is rare in this price range.
I bored up the rear axle output to 15 horsepower, but the suspension didn't lose any power, and the ride became quite tight.
In particular, the ride height is exquisite. If it is too low, the motorcycle will not be able to lie down because it will rub the side cowl, but if it is too high, it will lean forward and the front will be defeated.
I have been using it for about 10,000 km and there are no oil leaks, etc. I think the durability is very good.
View detail
Fits: YAMAHA Cygnus X, YAMAHA BWS125, YAMAHA BWS125
You can make a wide range of adjustments, and Anodized is beautiful!
What made you decide to buy?
In OEMRear Suspension, I wanted to raise the ride height because it rubs STAND Purchased
In the direction of Custom, I wanted a red color, so I went with this one
How was your experience with it?
First of all, it's beautiful to look at
I'm glad I bought it before I installed it
It's quite noticeable from the rear of the car, giving you a custom look
When you actually install it and drive it, the ride is hard but flexible, which is a strange feeling
It also raises the ride height, so it felt a little high on my hip until I got used to it
The matter of rubbing STAND, which was the purpose of the purchase, was lessened, but not for Zero
I haven't used all the adjustment features yet, so I'm going to try out different things in the future
Was the installation difficult?
The installation itself wasn't difficult, and I was able to replace it in about an hour, working slowly
However, knowing the tightening torque of the Bolt that has fixed the Rear Suspension You should have a Service Manual, because you need to have one
【Please tell me the installation point and hang】
The CYGNUS X has two Rear Suspensions, so I'll be replacing one at a time The length is different between the OEMRear Suspension and this product
So when you work, you can put your foot under the tire and move the tire up and down It works
[Was there anything that disappointed you?
The performance and appearance of the product is great, but the Instruction Manual is included and the product is very good I didn't know how to adjust it because I hadn't done so (Webike later solved the problem for me.)
Do you have any wishes or improvements you would like to make for the Manufacturer?
The Instruction Manual is pricey for custom parts for mopeds, so the Instruction Manual is I think it would be better to have
For a layman like me, it's hard to tell which Dial is an adjustment to what
[Do you have any products to compare it to?
B-MOON FACTORY Z-1 Rear Suspension
View detail
Fits: YAMAHA CYGNUS X, YAMAHA BWS125
Nice
In the past, I was using KS project SUO BUSOO Shock but Damper? Was too effective? Even if I loosened Spring to the weakest, it was too hard and I pushed Pushing from Spring Since it was uncomfortable, I changed it to Koch, I can adjust my damper so it will be my favorite fee Ring Recommendation. Weight also feels light with Reserver tank (I feel the same as light KN) Cost is ☆ 4 because the price is high. View detail