Reviews
Fits: HARLEY-DAVIDSON Twin camMODEL
Derby Cover Gasket (Bead Paper)
I use it when I don't need the metal gasket.
I hope it's a little cheaper
View detail
Shovel headExhaust Gasket
I replaced it when removing and installing the Exhaust System on the Shovel head. Compared to paper type, this product is easy to handle and reasonably priced. I have no problem using it, and I think it is a good product. View detail
Fits: HARLEY-DAVIDSON TC, HARLEY-DAVIDSON FVO
Good grip and easy to tighten.
This is the same timing as Lockling.
Flange nut has been using the OEM one for a while, and it became rusty and the tooling was not good, so I bought this one.
The result is a new one, but the height of the seat makes it easier to apply and tighten the tool.
View detail
Leak Prevention
Replaced to prevent leaks.
The work was done in a short time and the replacement was done quickly.
The quality and price were normal.
View detail
Fits: HARLEY-DAVIDSON OilScreenPlug, HARLEY-DAVIDSON All models TransmissionDrain plug
Use it to repair ShovelKick start!
When I repaired my Shovel head KICKStarter kit, I drained the Mission oil, so I removed the drain bolt with that Timing.
Then there was no Washer in Bolt.
The shape of Washer is different depending on the year of Drain bolt.
My Shovel had a semi-positive drain bolt on it, so the Washer I bought was perfect.
Be aware that some things may be Recoil'd and have a different Drain bolt!
I bought two of these for Oilfor Replacement, not knowing when they would break.
View detail
Fits: HARLEY-DAVIDSON all models of vehicles
Silicon grease
I think you should apply a generous amount of Cubbins Detective Silicon grease. View detail
Fits: HARLEY-DAVIDSON all models of vehicles
Silicon grease
I think it is better to build it with a lot of silicon grease. View detail
Silicon grease
Make sure to apply Silicon grease when you install it. View detail
Fits: HARLEY-DAVIDSON For S&S SUPERECarburetor
cheap
High quality with low cost performance View detail
Fits: HARLEY-DAVIDSON For S&S SUPERECarburetor
made of paper
It's probably made of paper, so it's more brittle than I expected. View detail
Fits: HARLEY-DAVIDSON all models of vehicles
Silicon grease
I feel like I need to apply more silicon grease. View detail
Fits: HARLEY-DAVIDSON For S&S SUPERECarburetor
Good Cost performance
I think it is a stable product because it is made by James and the cost performance is very good. View detail
Fits: HARLEY-DAVIDSON For S&S SUPERECarburetor
High cost performance
The price is cheap and very helpful. I want to buy it again. View detail
Fits: HARLEY-DAVIDSON DYNA Family, HARLEY-DAVIDSON SOFTAIL Family
No leaks, but... once and for all.
The Bead is a solid Paper Gasket.
Of course it is a good product to use without leaking.
We often open the Primary, so replacing it each time will cost you Gold.
I've reused JAMES GASKETS' METAL about 3 times now.
View detail
Slightly thicker than OEM
It's thicker than the OEM one, but relatively easy to install. The OEM one is too expensive, so I think this one is enough. After 10 years of driving, it will be cracked, so I used silicon spray to protect it a little and installed it. View detail
Because it is necessary
It is attached to Drain bolt by exchange of Transmission oil. Since it is necessary to exchange every time, do not forget to replace. O-ring has the role of Packing. If it is crushed or broken it will cause Oil leakage. View detail