Reviews
Fits: HONDA CROSS CUB50, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA CROSSCUB110
You should definitely loosen the Suspension as well.
Required Tools (reference)
5mm hexagon
10mmSocket
12mmSocket
14mmSocket
14Spanner
good point
Side bag is firmly attached.
A bad point
The instructions that came with it were not very helpful…?
The weight is heavy. (It can't be helped.)
I think it is very sturdy as a Side Support, even when I filled the side bag with water and somewhat heavy Japanese sake, it didn't give me any trouble.
I also used it to attach the Seat bag and had no concerns when pulling it upward.
When installing, you should definitely loosen the upper part of the Rear suspension.
The OEMRear Carrier rests on the upper part of the Rear suspension and the two Bolt points on the Tail lamp side, for a total of four points.
The instruction manual says to loosen only the Tail lamp side, but due to the structure of the Side Support inserted under the OEM Rear Carrier, the Rear Suspension must also be loosened or else the Rear Carrier will be raised up and the holes will not fit.
View detail
Fits Perfectly
The prodcut fits perfectly on 2019 Serow 250, however there are some chipped paint near the thread. But doesn't matter much. No misalignment or uneven when the DRC Side Bag Support was installed! Great product, good packaging too! Will recommend! View detail
Fits: HONDA CRF300L, HONDA CRF300L RALLY, HONDA CRF250RALLY(S), HONDA CRF250RALLY, HONDA CRF250L(S), HONDA CRF250L
Pipe feels thick and firm.
It could be used with DAYTONA's Grab Bar Carrier.
However, Bolt needs a long one.
View detail
Fits: HONDA CROSS CUB50, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA CROSSCUB110
Hmm
The position of the hole that attaches to the center of the Rear Carrier is off. If you don't loosen the screw which attaches to the rear tail lamp side, you can't bring the hole position to the center. If the screw which attaches to the rear tail lamp side is not loosened, the hole position cannot be brought to the center. I'll just have to use Spacer as a bite. View detail
Fits: HONDA CROSS CUB50, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA CROSSCUB110
Like more sturdy than other products
Since the rear suspension has been replaced, the Bolt of the rear suspension has been and instead of buying a certain product that uses a hole near the Tail Lamp to stop it, I bought the one made by DRC! As far as installation goes, the price and accuracy are fair The exhaust system can be installed on Both Sides even with the exhaust system up You can put Saddle Bag on this vehicle This is for people who don't want to CUB with other people or for people who want to carry a load but with the UPExhaust System View detail