Reviews
Fits: KAWASAKI Zephyr 750, KAWASAKI Zephyr 750
The texture is good.
I replaced the OEM Handlebar Switch as it was deteriorating and the quality is good as it is an Aluminum Diecast.
If you are familiar with old motorcycles, you will feel comfortable with the controls, but if you are a young rider, it might be a hassle (lol).
The Throttle holder can be used as is if the interfering parts are cut with a cutter.
It is quite difficult to replace the Accelerator Wire without removing the Carburetor.
View detail
Fits: Others , KAWASAKI Z2 (750RS), KAWASAKI Z1 (900SUPER4)
There's no doubt about it.
I installed it on my ZEPHYR750
It is used in Short Bracket.
It's good to have a choice of Bracket.
The shape is as good as DOREMIForme, but the construction is not as good as it should be.
I'm worried about the Conecto part of Bracket and Mirror.
Visuality is good.
Cost performance is good, so if it goes bad, you can repurchase it.
View detail
If you want the Z900RS to be a normal handlebar width
OEMHandlebar is wide That's what's often said about the Z900RS, but it's not as common as the ZEPHYR and ZrXSeries Handlebar width
The Handlebar Clamp is a Fat bar, so it remains an OEM Clamp It can be installed Also, you can keep the Throttle, Clutch Cable and Wiring as OEM It was
Plating turned out beautifully and we are pleased with the results
One complaint is that there is no dedicated Bar End
Quantity:Pair (for Left and Right) Since there is a hole for the convexity of the Switch box, the position of the Grip is also decided there The end of the handlebar will be inward about 5-6mm from the Grip As it is, the end of the handlebar is only about 5-6mm inward from the Grip Hmmm (Handlebar is short)
Perhaps you need to change to a shorter Grip and Throttle tube
By the way, the Bar End part of the product is covered with a plastic lid
The length of the OEM Grip is about 125mm, so a Grip of about 110mm would be good It is
Please note that the inner diameter of the Handlebar is 16.5φ
View detail
Fits: その他 Handle diameter 22.2φ general purpose, その他 Handle diameter 22.2φ general purpose
There are no OEM parts
Considered buying it because the handlebar is slightly bent due to the previous owner's fall Because the OEM Parts of Handlebar is discontinued, I bought it from Reproduct It is made by DOREMI
There is no problem in the shape of STD type But the difference from OEM is the thickness of the Pipe I'm not scared of it, but the Reproduct will bend when it's thin and impacted hellip; I think (I can't say for sure, as I haven't gotten up yet …)
View detail
Fits: Others , KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS)
Ideal for NAKED
I bought two. One will not blur, but the other will break.
Compared to OEM, it becomes Dress-up but visibility is lost.
View detail
Fits: その他 Handle diameter 22.2φ general purpose, その他 Handle diameter 22.2φ general purpose
Very nice handlebar, although it is slightly too wide to my taste. End up cutting 35mm per side (70mm total) to fit me nicely (see my profile picture) Bar-end is hollow, so you can't fit stock bar-end weights anyway
Very nice handlebar, although it is slightly too wide to my taste. End up cutting 35mm per side (70mm total) to fit me nicely (see my profile picture) Bar-end is hollow, so you can't fit stock bar-end weights anyway View detail