Reviews
Large sturdy even with narrow Jet holes
[How is it used? CarburetorMaintenance
Was the one you received as per Image? Almost as per Image
How was your experience with it? Easy to use
[Points to note] The thinnest Wire is the easiest to habituate.
How did it compare to other products? cheap
Other items that would be helpful
Points and hang for installation/Items to be purchased together/Opinions and requests to the Manufacturer It is recommended to use with Carburetor cleaner.
View detail
Because I went crazy when I overhauled it.
[How is it used?
The two deepest of the four shots can also be easily adjusted.
After closing off the screws, I put them back in, and since there was no memory, I made my own.
Was the one you received as per Image?
Yes
How was your experience with it?
I did it once without and the convenience was amazing.
Once you use it, you can't do without it.
[Points to note]
No Memory, so you need to do your own Arrangement.
How did it compare to other products?
unknown
Other items that would be helpful
Installation points and hang/Items to buy together/ Opinions and requests to the Manufacturer
View detail
Easy to use
I used to use hard copper wire to clean the holes in my jets and carburetors, but with this product, the material is very stiff and easy to handle. This product is very easy to use because of the stiffness of the material and the concave and convex surface to scrape the dirt out of the hole.
If there was another thin one, it would be great.
View detail
Carburetor It may be necessary for cleaning!
I used it for the Slow Jet route.
As the destination is like File? So lubricate oil to prevent scratching
I used it.
In my case the path is packed with things like O - ring fragments?
I was able to take out with this Tool and it was a great change to Large.
Moreover, it is saved that the price is reasonable..
View detail
Although an end part may be notched and it may be good for cleaning up, is a hole extended if it uses too much? Using a thin wire and 1000-sheet through now also by will be lost.
Although an end part may be notched and it may be good for cleaning up, is a hole extended if it uses too much?
Using a thin wire and 1000-sheet through now also by
will be lost.
View detail
"It was found while looking for the suitable tool to clean the jet of a carburetor, and I purchased immediately. Although a suitable wire etc. were used before using this, but thickness did not suit, or the jet made from brass might be damaged and it was
"It was found while looking for the suitable tool to clean the jet of a carburetor, and I purchased immediately. Although a suitable wire etc. were used before using this, but thickness did not suit, or the jet made from brass might be damaged and it was troubled truly, all were able to be solved thanks to this tool! The notch of a tool side is also very effective for removing dirt. Rigidity is solid even in the thinnest tool, and if it is this, I may use for a long. Probably, for who have many opportunities to fix a carburetor, it is indispensable item! If I mention dissatisfaction, since the point of the tool is sharp, when keeping in the attached vinyl case, the point is caught and it may not enter easily. However, considering cost performance and user-friendliness, such is only a small issue. It is a tool to keep in the tool box!" View detail