Reviews
For Helmet In Box of NC750X!
I bought the Helmet-in Pocket after watching one YouTube video of a NC750X Helmet In Box with the Helmet-in Pocket. The name of the product was carefully posted on the website, so I immediately searched for it on Webig and purchased it. I received the product and immediately started to install it. I purchased the M size, but I think the S size would have been better (the M size is also large and sturdy). I checked the installation location and then tightened it with the enclosed screw. It takes a little bit of strength, but I think it will be no problem for a healthy person. If you are a NC rider, please give it a try because you will have enough room in the box if you put a set of documents such as vehicle inspection certificate. View detail
Installed on JOG 2BH-AY01 Basic
*Small processing is required.
Tapping screws need to be fixed at 6 places on the SeatReverse side with +Driver.
The work itself was easy.
I am satisfied because I can store the instruction manual and CALI documents without folding them.
Since the Rear (around Engine and Seat) of 2BH-AY01 is the same as Honda's TACT
I think it is possible to install in the same way with TACT Basic.
View detail
Terminal processing is not good.
I bought this for an affordable Automobile Inspection Case.
Difficulty in terminal strength and sewing. Tearing occurred.
View detail
Items a must for NC riders!
Helmet inSpace for NC750X.
It tends to clutter up with documents and small things, but if this is attached, such a problem is solved.
Helmet in, Fastener and Mesh pocket can be stored separately in a large size.
I tightened it to the screw that was originally there.
Only the bottom part was cut to pull out the rubber, but it is a product that can get a large effect with a little processing.
View detail
I recommend it without question
I have no complaints about the price, installation and texture
Neatly stores documents that tend to get cluttered inside the Helmet in It helps to keep the Helmet in clean and tidy
View detail
It is CYGNUS X 3 type Just fit
CYGNUS X 3 type of Seat "Helmet-in Pocket M" Wearing.
Size is also good, Just fit.
Price can also be recommended cheaply.
View detail
Unexpected force required for installation
The installation can be done only with six Tapping screws in the plastic part of the back of Seat.
but,
Material behind Seat is unexpected hard .... (It usually seems pain hurts)
- Carefully decide the installation place, mark the place of the Screw hole in advance. (Clap and Screw do not have the same diameter, so it is difficult to drill holes as it is)
- Attach a dent to the extent that it does not Penetrating with dust etc.. (Penetrating makes it easy to become a pinch of holes, so keep it in front of it)
- ScrewSingle Body (Do not set Clamp or Body) To the depth where Screw will not fall (About half) Screw into Seat.
- Once you have 6 places to remove Screw, Clamp - Set Body and reinsert Screw and install.
Anyway Seat's material is stiff (White in particular).
Electric Driver. (I recommend you remove the Seat)
Do not fully tighten from the beginning, work on it after checking the position where it does not interfere.
Mesh pocket, Zipper pocket, Body Inside and three storage spaces can be made. (Heavy objects are impossible - - Because Rubber grows)
View detail
Refreshing!
It installed in SPACY 100.
Helmet In Box refreshed with registration certificate and detailed items can be stored.
It is useful because it is also highly universal.
However, since Seat base is hard, Screw that is enclosed will not dig into unless you can not open a hole.
It is not due to this product.
View detail