Reviews
Used for SHOEIEX-ZERO
This size is ideal for helmets that do not have speaker holes like EX-ZERO and have no space in the mounting position.
I have used the standard Speaker and the thin Speaker, but the Smallest is the thinnest and the sound quality is the same as the others.
The price is a bit high, so IncomeQuantity:It would be appreciated if the Speaker of the Set could also be selected.
View detail
Required when using different Helmet depending on Motorcycle
It is convenient to purchase multiple Bases so that you can use multiple Helmets. View detail
This is my second purchase!
This is my third IncomeBody, including the Body, and it is very useful because I can easily port it to multiple helmets with just one IncomeBody. (as a prerequisite that Body likes it). In terms of price, I chose this one because it costs about 8,000 yen, which is cheaper than the less expensive Income. As for the installation, I installed it in each of the three manufacturers, ARAI, SHOEI, and CUBT, and it was easy to install in all of them. I am generally satisfied with the product, but I am not so sure about the thin type Quantity Speaker, even though Daytona has released a Thin Type Speaker.:It is a shame that Set has not been released. View detail
It's neither good nor bad
I purchased a new adhesive Seat because I needed a new one to replace Income.
Naturally, since it is a DAYTONA OEM, we were able to use it without any problems in terms of size feel or adhesive strength.
However, even if you only want a sticky Seat, you can also specify a Quantity for the Parts of Others.:The problem is that each purchase of a set is a wasteful increase in the number of parts.
Also, perhaps because otherParts are included, the sticky SeatQuantity:I also felt the price was a little high for a 1pc.
However, in general, I have no particular complaints and will consider purchasing one if and when I need it.
View detail
Purchased to use different Helmets.
I purchased the DT-01 to use with both the Jet helmet and the Full face helmet.
I installed it on a SHOEI Z7.
I was struggling to put it away in Beauty anyway, referring to the Net information.
It took a long time, but the result was satisfactory.
I felt the price was a bit high, I hope the cord does not break.
View detail
To prevent the DT-01 from wobbling
Full face helmet (arai XD) I installed the DT-01 on my car, but it seemed that the intake was not seated properly and it was wobbling. I was dissatisfied with the operation of the buttons, especially while driving, so I re-installed it with two layers of tape as an anchor, although this is not its original use.
The adhesive strength of the Double-sided Tape is weak, but thanks to it, the Income sits better and the wobble has been mostly eliminated.
I'm going to use it for a while to see if it peels off.
View detail
Shiningly
The Helmet is Black with Mirror shieldSpec. so I like the fact that it is Shiningly in my opinion. View detail
Color Coordinates
I bought it to distinguish between my wife and myself. I thought it would be nice if it became a little less expensive though the thing was good. View detail
Microphone for Full face helmet 。 DT-O1 DT-E1
Microphone and other parts are available as Repair Parts for DAYTONA's IncomeDT-O1 and DT-E1.
Velcro tape for sticking is also included for easy replacement.
When you use multiple Helmets, you can use the same Body and leave the Microphone & Speaker in the Helmet.
I am glad of the attitude that treats such Repair Parts as a standard product because it is possible to use it.
It is easy to replace (connect), just plug it into the yellow Connector that comes out of the Body.
Performance wise, it's just a normal Microphone, it's a Repair item so it just goes back to new.
If I wanted to...
The smaller the size, the happier I am, just like the Earphone in the Included Parts:section of the phone.
Because Helmet's mouth will be easy when the Size is about the tip of a cotton swab.
It would be interesting to make the Repair item Variation more aggressive than the Standard Product.
MINIMINIMicrophone for Full face! I'll probably buy it again when it's released.
View detail
In reserve!
Repair Parts for DT-O1
After reapplying it a few times, it lost its adhesive power, so I bought it as a spare.
It has two in it and will last for the time being.
View detail
Income replacement.
AllQuantity Adhesive Tape is AllQuantity:It's a set so you can relocate Income when you buy another Helmet or Helmet. It makes sense. [Contents] It is View detail
Easy to replace.
I bought a Single Item for my IncomeDT-01 Microphone sponge because it was torn. It was easy to replace it. If you pull too much, it is easy to break, so you need to be careful. View detail
Necessary to replace it nicely.
It is not used for the time being, but I bought it because I thought I might need it when replacing the Helmet.
This can also be used by cutting the Universal Product, but I bought it because I want it to stick nicely.
View detail
Necessary for a clean installation.
I bought it to replace one Income with three Helmets.
You can use the Universal Product in the normal way, but the dedicated product can be installed more cleanly.
View detail
Makeover to suit your mood
The replacement of the panel itself can be done without any tools because it's just a clawed-in replacement. There are many other colors available, so it is good to match the color of the Helmet. View detail
I can co-ordinate with Helmet
Blue Face panel is chosen to match the Helmet
It's a Recommendation because it can be easily replaced
However, I thought the price was high
Material of this Size:I feel that less than 1,000 yen is a very strong price setting for plastic products
View detail
very helpful.
I like this kind of exchange kit firmly, I will continue to consider Body when purchasing, exchange Helmet, there are multiple cases will be saved. Easy to install! View detail
It is a good item
I bought this set to use the Body of Easy talking 3 with another Helmet.
I wish I had become Speaker and Set, but ordered separately.
View detail
Finally I could use it!
Actually, this product was the 2nd purchase. I bought it for EASYTALK 3 in the past in the past but I returned it without using it. At that time I sold it for GT, but I sang it on the maker website and I bought it with WeBike. However, it can not be used in practice, it can not be used as a result of inquiries from manufacturers, and refunded with returned goods. About one and a half years after that I found information that it can be used for EASYTALK 3 at another site and consulted with the manufacturer immediately. Then it seems that it can be used if you replace the speaker part with an improved type by being able to use it with some improved EASYTALK 3. So we were happy to exchange with carriers at the manufacturer, we purchased this product again at WeBike and it was able to be used sunny. By the way, the cover of the old jack speaker is brown and the new countermeasure item is black. It is finally usable with the kind response of the manufacturer, it can be charged even during use, it becomes very easy to use without worrying about use time. View detail
I replaced her Helmet
I bought it for Easy talking 3 because I replaced the new Helmet. Installation was possible without problem. I will be saved if it is a bit cheaper... View detail