- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Exhausts
- Full Exhaust System
Reviews
Fits: HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY, HONDA MONKEY
Large hands and Large success!
It is attached to Formula MONKEY 2007.
Impression after about 2000 km driving.
<Vehicle Spec. >
○ Engine
Takegawa17R Bore stroke up106cc
○ Mission
TakegawaTAF5-gears Cross Mission Kit (Super Street)
○ carburetor
KITACOVM 26 Pilot Jet only # 12. Change to 5
○ Clutch
Takegawa Secondary side Special clutch
○ Ignition system
NORMAL
☆ regarding mounting
Even novices can be assembled if you look at the manuals. Joint part with Silencer, there is no exhaust leakage from the exhaust manifold. However, exhaust leaks can be seen through the gap between the lidded stoppers at both ends of Silencer. Let's apply liquid packing.
When attaching OEMHeat Guard, tighten while adjusting the direction of rotation of Silencer.
☆ Idling sound
Bore up car also somewhat bigger than OEM obviously Large, perhaps quiet residential area, even in the early morning is acceptable range.
☆ When accelerating
Because this is also a Bore up car, pretty ursay. Especially, pops pops on the ear. There seems to be no occurrence of the type of Chatter sound of Exhaust System.
☆ When cruising
Sounds themselves are not uncomfortable with large ladies. However, the probability of being stopped is high.
☆ During deceleration
Besides being quiet
In order to improve the situation above, we made the following remodeling at your own risk.
The basic structure is a straight structure that silences with Silencer with Glass Wool wrapped around Punching pipe.
How far the end of the exhaust manifold has extended to about 70% of Silencer. Punching is available only in the vicinity. Of course Glass Wool in the place without Punching was like a brand new item. It is a wasteful way of use.
Since Glass Wool has a silencing effect on papa pac, at the entrance of Silencer,
Cut it and add Punching processing to the part which was not available. Glass Wool used POSH.
With this, when exhaust gas goes through Silencer, it should be silenced to the extent that it is disgusting.
result
☆ Idling sound
Almost no change.
Sound slightly rounded up.
☆ When accelerating
Unpleasant papa sound was reduced considerably. It is a passing score.
It seems that slow Torque is not sacrificed either.
It seems that there is no place where it is getting worse from low speed to high speed.
On the contrary, it does not say that it became like to turn well.
☆ When cruising
I can run comfortably.
It is quite a bit too quiet.
☆ During deceleration
Almost no change
Temporarily assembled and check it after traveling several kilometers
It seemed that exhaust gas Gas was running around almost all of Glass Wool and was silenced effectively.
In my case I got a target result, but Motorcycle and OthersSpec. In some cases, similar results may not be obtained. In case of being referred to, please take it self-responsibility to the last. (Because it can not be reversed)
View detail