Reviews
Ring cannot be removed. Tool won't fit.
The tip was too thick and the hole was too narrow for the z1 Master Cylinder to get the Ring. View detail
The equivalent device was sold at a bargain price in the home center. Although it is good since it purchased in order to float a mailing cost .. I think that it is quality.
The equivalent device was sold at a bargain price in the home center.
Although it is good since it purchased in order to float a mailing cost .. I think that it is quality.
View detail
You can do minimal work
I purchased it because I was attracted by the variety of advanced tools and the low price of the price.
Although it is hard to do, removal of Circlip is possible somehow.
We use KTC's Tools Set at work and the usability of this tool is at least Level when compared with KTC tool.
However, since the KTC tool is very expensive, I think that if you are Sunday maintenance Level, the selection like this item is cheap even if it's difficult to use.
View detail
It probably is reasonable.
Although I have not used it yet, as far as I can see, it seems that there is no problem in using it with Brake Pedal Shaft of VIRAGO, but it is slightly uneasy in terms of strength to use for KLX Drive sprocket exchange. View detail
Fits: HONDA ADV150, HONDA PCX125, HONDA PCX125, HONDA PCX160, HONDA LEAD125, YAMAHA NMAX, YAMAHA CYGNUS X, YAMAHA CYGNUS X FI, YAMAHA CYGNUS X SR, YAMAHA CYGNUS X SR, YAMAHA MAJESTYS, YAMAHA NMAX155
Early, but ...
Unlike the Holder of the type to be tightened, unlike the Holder of the type to be tightened, if you adjust the Size, you can operate with One-touch so you can work efficiently, but the scenes that can be used will be limited as well.
I practically use it only when fastening Flywheel like a photo. In this usage case, this type of tool is faster because the operating angle is limited when tightening Type.
However, since it takes plenty of space in the tool box more than not to be used much, I can not recommend it except for those who can afford Space.
For those who are looking for the first tool to fiddle with Scooter or who want universal nature, we recommend Holder of type to be tightened.
http : / / www. webike. net / sd / 21784446 /
There is a Type with a "claw" on the inside with a tool similar to this, which can also be used for Pulley with teeth on the outer periphery, like Honda type, so this type is recommended here.
http : / / www. webike. net / sd / 21331222 /
As a digression, since the tool of this hand has no unified name, it is troublesome when searching. Universal holder, Pulley holder, Fly Wheel Holder, Scissor Holder, HandHolderetc. ...
View detail
It purchased in order to correct direction of the analog oil temperature gauge made from a daytona. I think that it was high shopping since there was a use only in this for the moment.
It purchased in order to correct direction of the analog oil temperature gauge made from a daytona.
I think that it was high shopping since there was a use only in this for the moment.
View detail
Since a band is a stainless to be sure, it is the goods as a name, but a bolt is iron. I think that it searches for the reason of only rust prevention since there is no stainless also lightly. But is it meaningless if iron components are used?
Since a band is a stainless to be sure, it is the goods as a name, but a bolt is iron.
I think that it searches for the reason of only rust prevention since there is no stainless also lightly.
But is it meaningless if iron components are used?
If consumable goods are considered, I will also use a band as iron and will consider it as it is better to make it cheaper.
Very halfway goods.
It is regrettable.
View detail