- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Drive Parts
- Clutch Holder
Reviews
It looks nice.
It is a hassle to put the Wire Stopper in the Clutch holder. View detail
Is the reduction effect small!
To replace the OEM Clutch Lever, it is necessary to remove the Bar End, Grip, and Switch Box, and it is necessary to be prepared to replace the Grip depending on the situation. We tried to install and adjust it in combination with Unicorn Japan's 2-way clutch release arm, which was introduced earlier, but we could not feel the effect as much as the combination of OEM clutch lever and 2-way clutch release arm. I did not notice much effect compared to the combination of OEM Clutch Lever and 2-way clutch release arm. I think it looks a little better, but I have to evaluate that the cost performance is low. View detail
The range of motion may be too wide.
It is good that the pull on the Clutch has become lighter, but the pull range has become wider (Large). (It is a matter of course) Therefore, it is possible to pull Lever farther to Quantity:Because it has to be set, and my hand is not so large, it becomes somehow difficult to handle. It is the main point of view.... View detail