Reviews
Excellent
They are made from composite material and lighter than the stock ones Thinner and more elegance, especially with sr400 gas tank. You need to remove air box and to relocate all electric parts from left side. View detail
If it was just a little cheaper..
These parts are not for performance, but to change the appearance of the CROSS CUB However, when you install this Beak Cowl, it looks like a V-STROM! to change This is why I am looked at twice by other motorcyclists Yes! View detail
To install these side covers, it is required that you use the Electrical Equipment Holding Plate (W-EP1). You will also need 2 K&N air filters (W-RC-0981) and a K&N breather filter (62-1020). In addition, you will also have to install new jets and tune yo
To install these side covers, it is required that you use the Electrical Equipment Holding Plate (W-EP1). You will also need 2 K&N air filters (W-RC-0981) and a K&N breather filter (62-1020). In addition, you will also have to install new jets and tune your carbs to make up for the added air. Straight forward install. There are directions online on how to remove the stock air box. Some of the electronics get installed on the holding plate then everything gets tucked snug. These are flexible and fit well using your existing bolts/screws. View detail
Nice side cover. Fit well and, as shown in the picture, shows off the aftermarket air filter. I sure can't find any fault in it and am pleased at the new, clean, compact look.
Nice side cover. Fit well and, as shown in the picture, shows off the aftermarket air filter. I sure can't find any fault in it and am pleased at the new, clean, compact look. View detail