Reviews
Tightened with a slotted screwdriver.
Used to replace an oil line. It seemed to be able to close it with a hexagon, but it didn't fit slightly. I think it is a millimeter. View detail
Fits: HARLEY-DAVIDSON Fits OEMCVCarburetor
No installation problems after a little sharpening.
The surface treatment of the slide valve seems a little rough, the OEM was the same, so no problem.
Because the negative pressure presses the Slide surface Rear against the sidewalls, especially the areas that are strongly hit are polished and shining.
If the corners and flat surfaces of the PAL blade wings are polished with a gold-based polishing compound and installed, the initial sliding will be smooth.
View detail
Fits: BUELL All vehicles 91- (except 1125R), HARLEY-DAVIDSON SPORTSTERFamily
To remove the Primary.
Used to remove Primary.
It is rather expensive but easy to use.
View detail
Fits: BUELL All vehicles 91- (except 1125R), HARLEY-DAVIDSON SPORTSTERFamily
It's solid
I bought the special one in advance so that I would not have to worry in case of a breakdown. It is expensive but well made. Cost performance is not good. View detail
Super trap Diffuser Disc Mounting Bolt
I considered buying this as a replacement for the Super trap and Diffuser Disc mounted Bolt. View detail
Don't lick it.
It is better to apply the tool firmly so as not to lick it. View detail
rust removal
I think you should do Rust removal on a regular basis. View detail
HexBolt。
I'm grateful to be able to buy from Rose. View detail
It might be a little rusty.
Inch size is hard to find, so it is very helpful. View detail
If Rust is
It's starting to rust a little, needs some Rust treatment. View detail
As for Bolt.
I think the quality is better for Bolt. View detail
that's right
It's not sold in stores, so it's very helpful. View detail
that's right
It's not sold in stores etc., so it's very helpful. View detail
For HARLEY!
I'm using it on my '06 XL883R. it was my first time to tweak a Harley, but it looks like this type is used in many of the Horse clamps. I didn't mind anything, but I got the same type. I don't have any problem to use this type of Clamp. View detail