Reviews
Indicator bulb out of service.
It was used due to a broken bulb in Indicator.
It's working fine
View detail
On a ball run out.
I bought this for replacement because the bulb was out!
It was fixed normally!
View detail
It worked for now.
At least it worked for now;
I am concerned about how far it can be used.
I hope it is Large sturdy…
View detail
Back, I have a theory that it will be unavailable.
I used to be quite fond of the Black GlassTube for protecting the Wiring section, but I had wondered why Black was being discontinued in many Cases recently.
Apparently it's part of the global regulation of rohs? The Black GlassTube is apparently out of stock.
I'm not sure how beautiful it would be to have a BlackFrame with White GlassTube protection.
View detail
Fits: HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON DYNAFamily, HARLEY-DAVIDSON TOURINGFamily, HARLEY-DAVIDSON SPORTSTERFamily
I think it is the same as OEM.
I used this when I replaced the exhaust pipe in North America.
I bought it because I had been removing and replacing the one already installed and it was getting loose and I didn't know when it would crack due to rusting.
I was under the impression that it was a little thinner than OEM. I had the impression that it was a little thinner than OEM, but I was able to install and tighten it without any problems.
If you are not particular about OEM, it's ok.
View detail
Fits: HARLEY-DAVIDSON SPORTSTERFamily
it is normal
It is a small part, but it is helpful to have Lineup.
The difficulty of the exchange was low and it took a short time.
View detail
Fits: HARLEY-DAVIDSON S&STeardropAir cleaner
The overhang is
If you don't mind the overhang, you can get very good intake efficiency. View detail
Fits: HARLEY-DAVIDSON For vehicles equipped with S&S Teardrop Air cleaner and High flow Air filter kit
And loose.
It won't loosen if you apply a loosening compound and tighten it properly. View detail
Fits: HARLEY-DAVIDSON SPORTSTERFamily
The finish is not so good.
I bought it because it was the cheapest for XL1200C SPORTSTER 1200C.
The fit was correct, but the holes in the Plastic were not completely drilled and had to be cuttered to fit.
After installation, the car runs without any problems.
View detail
Fits: HARLEY-DAVIDSON For vehicles equipped with S&S Teardrop Air cleaner and High flow Air filter kit
anti-loosening
Use an anti-loosening agent or the like, otherwise it will loosen. View detail
Fits: HARLEY-DAVIDSON S&STeardropAir cleaner
I got a little leak.
Whether it's because of the heat or the vibration, the applied Oil leaks a little and splashes around. View detail
Fits: HARLEY-DAVIDSON For vehicles equipped with S&S Teardrop Air cleaner and High flow Air filter kit
Accuracy
It's highly accurate so it won't rattle. View detail
Best for heat resistant Wiring part
I used NeoFACTORY's Colgate tube and it was good, so I bought the Silicon tube this time.
The effect of heat resistance is not understood well yet, but I tried to adhere to the Engine which became hot, but I think that there is heat resistance effect and it is not easy to kink, so it is helpful.
Anyway, the price is cheap, so it is very helpful.
View detail
Fits: HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON SPORTSTERFamily, HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON SOFTAILFamily
Thanks for the low price tag.
It is an accessory part of the Slip-on Silencer, but it is an unexpectedly expensive part.
I bought it because it was the cheapest on the mail order site.
I don't know if it's OEM or not, but it doesn't mean it won't run without this part, and as long as it's installed and there's no exhaust gas leaks, there's no problem.
I actually put it on and it doesn't feel strange.
When you remove and install the exhaust system in maintenance, this part will be damaged. (Some wear and tear will occur even with a sequential change)
Since there is one exhaust system and two exhaust systems, you will need two to replace the parts.
Because the regular price is over $1,000, it is thankful that it can be purchased for a few hundred yen because it is quite an expense, Large change.
View detail
Fits: HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON DYNAFamily, HARLEY-DAVIDSON TOURINGFamily, HARLEY-DAVIDSON SPORTSTERFamily
Note the length
Because the Idle Cable ran out and Axel did not return, I replaced it (Same as Idol's impresario)
This time, Idle Cable (Back Side) Because it was broken, but because I replace it anyway, Throttle Cable side (Pull Side) also I bought it at the same time and had it refreshed
Because there were many kinds of cable length, I tried to measure the cable length installed and tried to make the cable length similar to the cable length Choice
To replace the wire itself, remove the air cleaner and shift the carburetor to that point It didn't take a lot of time and took about 30 minutes I injected the lubricant Spray into the Wire to the extent that I was comfortable with it and blended it in
View detail
Note the length
Because the Idle Cable broke and Axel did not return, I replaced it
This time, Idle Cable (Back Side) Because it was broken, but because I replace it anyway, Throttle Cable side (Pull Side) also I bought it at the same time and had it refreshed
Because there were many kinds of cable length, I tried to measure the cable length installed and tried to make the cable length similar to the cable length Choice
To replace the wire itself, remove the air cleaner and shift the carburetor to that point It didn't take a lot of time and took about 30 minutes I injected the lubricant Spray into the Wire to the extent that I was comfortable with it and blended it in
View detail
Price suitable
I feel like VINTAGETape is a different thing. Because it is Fleece, I will fluffy.. Whether Tape itself is thin, or if it is 1 volume, it looks transparent. Although it is weak, it sticks normally and you can use it. View detail
Fits: HARLEY-DAVIDSON TOURINGFamily, HARLEY-DAVIDSON SOFTAILFamily, HARLEY-DAVIDSON DYNAFamily
Expect durability
After swapping to HSR, purchased for a little special Air cleaner purchased from United States from second hand purchase.
It is for Teardrop, but we made and installed Color.
There are rumors that durability is not so good, but there is no problem even if it is used for 1 year.
Because it is easy to break, it is caution to over tighten.
View detail
Use for just a moment
I bought it to replace the LightBody and to install it together, ... I dropped it on the floor with Light when attached, it seemed that I banged Valve 's connection part ... It got useless in 2, 30 minutes Was.
Although it may not hold as Impression ....
I feel that the difference between HIGH and LOW is Large. LOW side felt close to OEMValve color. I usually thought that I wish I would use White more than just using LOW a lot.
I think whether it is expensive compared to things of around 2 thousand yen at home center and around 1,000 yen. Perhaps I expected too much performance, but it is same as the cheap item of Home center. I think that it is the performance of, and it is the real thing that it does not hurt even if it fails cheaply. Since Halogen disappears soon, consumables are expensive, so I also want to lower Cost.
By the way, ...
Failed (I dropped it like me) If you are using Valve ... which is Valve you will be ..., it is obvious that the bulb is out, Meter's HIGHLamp will remain lit even if the Light switch is set to LOW, why the Front RightBlinker will not be attached and why Whether the voltage goes down or the auxiliary light also turns off (low rotation - It lights up in Idling). What a symptom appeared.
Although it was impatient considerably, although it was said that it was mild or replaced with Valve, it was all restored, but in severe cases it seems that Wiring etc melts and it is dangerous anyhow.
As a matter of course, do not drop anything, do not use doubtful Valve.
View detail