Reviews
General Hose Band!
[How is it used?
I purchased this product as a FOR REPAIR because the Oil cooler hose band I use has rusted over time.
How was your experience with it?
The type is tightened with a slotted screwdriver, so it was difficult to apply Torque when tightening.
I think Phillips Screwdriver is easier to tighten.
How did it compare to other products?
It gives the impression of being cheap compared to other products, but since the use is for the Hose Band, there is no problem if it is considered a consumable product.
[Points to note]
Screw part is steel, so it rusts easily.
However, it is rare to find a Hose Band that is all Stainless Steel, even in other products, so this is not an option.
View detail
I like that it has a lid.
The lid is attached to the
Prevents contamination of Garbage, etc., before the next Oil change.
Since it is not possible to wash it every time, it is left as it is after use.
The next time you use it, put Oil into it.
The lid is helpful because you don't have to worry so much about Garbage contamination.
The container itself is thick and sturdy, so it can be used for a long time.
View detail
It's not often, but it's handy to have.
We have a lot of motorcycles stocked in our garage. We have a lot of motorcycles in the garage, some of which have been sitting for years, so when we want to ride them on a whim and do a little maintenance, sometimes the brake fluid is replaced and the blizzard cap deteriorates and breaks. This is for such a case. View detail
Folds into a compact package.
It folds up and folds down to make it compact and easy to store. It can hold up to 9 liters of water and is just as large as a regular bucket. View detail
Car wash essentials
Very useful.
As you use it for a long time, the water that you put in it will seep through, but it's not leaking.
As the bucket gets older, if the water level in the bucket gets low, the bucket may collapse and flood with water.
I think it's durable enough for the price and ease of use.
I can recommend this product!
View detail
Sometimes Ha Gap is in the mix
I use it to install Cowl and Screen
I'm thankful that you can buy the Anodized TreatmentBolt for this price Due to a defective processing of the screw part, some of them do not allow the nut to go through to the neck
The ratio is about 1 pc per 10 bottles
I originally bought it with the calculation to have a few extra bottles, so it wasn't a problem, but the required quantity Exactly Purchasing it could be a hassle
View detail
color - - -
It was a bit disappointing that I bought M6 and M5 of the same type and it was a bit disappointing that each color was different in color, M6 was a bright color Gold M5 was Orange Pov gold, Orange ぽ い Gold himself I was sorry for the direction of M6 as it was good.. I think that comprehensive was good as it is easy to purchase price. View detail
It can be used normally.
I was attracted to cheap and bought it.
I could perform cutting of Wiring, film peeling, crimping of terminals without problems. Until now, I used Radio pliers and Pliers to process Wiring, but when I use a dedicated tool, the workmanship is still different.
Electric Works Pliers was the first purchase, so I can not compare it with other things, but I think that it is not a bad thing because I was able to do the Wiring process normally. If it is occasionally used, it seems possible to use it without problems.
I kept it in an outdoor warehouse, but it rusted considerably. It is the rust condition of Level same as Haku-ya's tool. It seems better to care for frequently.
Although it is a difficult point to rust immediately, workability and completeness of Wiring processing is high as there are only special tools. Blinker exchange, Headlight exchange etc. etc. Those who are considering the Custom of the electrical system of I think that there is no loss.
View detail