Reviews
Last year 44,000 yen ?? now 72,000 yen. I'm so disgusted by the vicious price hike.
The FRP fender was replaced by a Carbon fender from Kuh LaborWolf.
Easy to install. Just fit, unlike foreign products.
It's just...
The price was about 44,000 yen until last year, and now it has been raised to about 72,000 yen. Front has also raised its price, but Rear's price is worse. I think the price increase of less than 30,000 yen is quite malicious.
Moreover, it is uneven. (image) It is noticeable. The quality is not very good either. 72,000 yen for this quality and I regret buying it. I would like to return it, but it's non-returnable.
I don't think I'll buy KuLaborWolf anymore.
View detail
Discoloration after 4 days of installation.
It has been 4 days since installation and some of it is now White blurry.
I requested a replacement, but if you are concerned about discoloration, Urethane [Color] The reply came back that I should blow Clear.
It's been on for four days! That's a lot of discoloration, isn't it?
Stunned by the worst product and response. (*_*)
View detail
Cannot be installed on OEMHarness
In conclusion, it cannot be installed.
It is listed as a YZF-R1 15-19 fitment, and is claimed to be for the OEM harness and ECU.
If you buy this bracket, you can't install it on the OEM Normal harness or ECU.
Specifically, this bracket requires the ECU to be installed in the Up position.
The OEMHarness is absolutely not long enough and can only be mounted horizontally.
In addition, it interferes firmly with Side cowl when it is installed sideways forcibly with Tie Wrap etc., and it is not possible to use it.
Cowl installation becomes almost impossible, and worst of all, it cracks. The Cowl surface cracked for me.
I've inquired about it, and as I suspected, you've had similar communications in the past.
"You can't use it in OEM mode and it's not recommended. If you do use it, remove the Tank, undo all the Harness, and stretch it out." They seem to be guided by the
Sure, that might be possible, but in that case, it should be stated in the description as a prerequisite, and
I feel that this is far from a guarantee of conformity in Webike.
What the heck does the product name "For OEMHarness" mean?
However, if you are considering to install CW's Race cowl on a NORMAL vehicle, it is better not to do so.
I honestly feel like I've been scammed.
As long as this Bracket problem is not solved, I can't even use my expensive Cowl properly lol.
Above all, I think that it is very problematic that even though there was a similar inquiry in the past, not only has it not been improved, but not even a warning note has been included.
View detail
correction
At first it seemed to be okay ... Although some gaps still tougher as a tolerance are still attached for a few months, yet it is covered and it is climbing on Pad itself, it is just a defective item. Durability is slightly less than two months. It is better not to buy. View detail