Reviews
Too short
Made from nice and solid steel, pleasant to the touch. For my purposes and my lamp it turned out to be too short. The headlight was flush with the fork legs. If it were Z-shaped and 5 cm longer, it would be ideal. View detail
Looks and builds well.
This product is a replacement for a short fender+Lucas lamp made by DAYTONA for SR400, but the R of this product and the fender do not match.
At first, I put it on forcibly as it was, but the Number shook a lot due to vibration, so I bought a Rubber Sheet at Home center and put it between the gap and the License Plate.
After that, I re-drilled the holes in the Fender to reattach it a little closer to the Seat, and replaced the screws that came with the Fender with Firmly screws.
View detail
Fits: HARLEY-DAVIDSON XL1200C SPORTSTER 1200 XL
A little troublesome
We are tightening together with Bolt of Engine Mount on the Frame side, but in my 2012 XL 1200 N the hole diameter was too small and Bolt did not pass. It is necessary to shave a little by spreading it with a ruther. Also, Bracket uses Color : In case of Unpainted, it will be rusted soon so it will be better to paint.
Visibility is not as bad as I thought. I got lost as made by Easy riders but the movement of the line of sight is few as this is attached to the front. Well it's hard to see from any OEM position anyway.
View detail
Fits: HARLEY-DAVIDSON XL1200C SPORTSTER 1200 XL
Comparison with easyriders products
I replaced it from SIDEMeter mount made by Easy riders. As I made it into Rear Sets, Mount was stuck in the vicinity of the knee with Easy's thing but solved it instead. Offset over 20 cm on the Front side.
Trust Motor rock, even though it is built, is solid. Regrettably this is compared with Easy's Tsujimi paint This is Stainless background + gloss Black Painting. I think that there is liking, but I think that Easy was better in texture.
Removal of the plug on the front side is a little difficult to do afterwards (It is not impossible).
However, Large satisfied that the knee contact which had been worrying for years has disappeared!
View detail
Fits: HARLEY-DAVIDSON XL1200C SPORTSTER 1200 XL 95-09
He would like to finish a Motorcycle narrowly and the Parts here is chosen. of attaching a Blinker shapely by the width in front of a satisfactory and Frame width was able to be carried out. I think that it is an apt Parts to make narrow touch
He would like to finish a Motorcycle narrowly and the Parts here is chosen.
of attaching a Blinker shapely by the width in front of a
satisfactory and Frame width was able to be carried out.
I think that it is an apt Parts to make narrow touch to the
Motorcycle.
At the time of the
automobile inspection, seemingly since honest width is narrow, it is unreasonableness.
View detail
Texture is good at finishing of the Hairline style. upper and lower sides -- although direction of which can also be mounted, since it is located in the place where the light extended far back a little, when attaching at least by a positive, it is
Texture is good at finishing of the Hairline style.
upper and lower sides -- although direction of which can also be mounted, since it is located in the place where the light extended far back a little, when attaching at least by a
positive, it is a check required about the Clearance of a Headlight case and a Stainless shaft.
View detail