Reviews
Large amount of Split Pin
[How is it used?
The TZr250R uses split pins in several places, and it is a hassle to choose the right size, so I decided to use Quantity.:I was looking for Set.
Was the one you received as per Image?
As you can see in the picture, the Large amount of Split Pins were separated by Size.
How was your experience with it?
Compared to the OEM Axle Shaft Split Pin, it was a little thinner even though it was about the same length.
The thinness makes it easy to bend, and since it is not a place where loads are applied, I personally found it easy to use.
I think the legs are a little long, but it's acceptable.
[Points to note]
The 2Size Left has 150 sticks in one divider, so it's easy to go through the side dividers. LOL!
You need to check the size carefully when using the actual product.
How did it compare to other products?
I thought about buying the OEM one, but it's more expensive and I need to stock it for when I need to use it.:I chose this product that came in a Set.
If you know the size you want to use, you may be able to use the ones sold by Rose at Home centeretc.
【Review】
It comes in a large quantity and the price is not that expensive, so it is good to have one if you are a frequent maintainer or have multiple units.
View detail
Split Pin should be used as a general rule for a new product.
The RZ uses the Split Pin for the Front wheel and Rear wheel nut locks. Of course, it is possible to buy them from OEM, but the price and delivery time are reasonable. minimoto's Split Pin is 555ps and cheap. I used to take it off and reuse it to avoid breaking it, but I've been using a new one since I bought it. View detail
periodic replacement
Price and Quantity:1 Set of 2pcs It is purchased with other products on Oilfor Replacement
It's a consumable product and that's enough
View detail
To use
I used it on my Kawasaki Z2, it works great, now I'll use it on my TDR20 I used to build without RingCompressor, but it's still easy, Home! I bought a aluminum block at center and made a PistonStopper by myself Then you can put in 4 cylinders with Scauper
View detail
Cospar good
Material : Aluminum may be better, but it was too cold to stick to Drain bolt and I had a hard time withdrawing it, so I tried using copper ones. Of course Oil leakage is not present at the moment. Make sure that it is easy to remove it at the next replacement, if it is okay, I think that this price is cheap enough.
View detail
Minimoto DrainCook packing I ordered.
I will use it at the next Oil change, I have not used it yet, so I can not comment, I have decided on this product, once I looked at the comment in the introduction column of the product, everyone's opinion I put a check on a good point, I am afraid I do not know well as I do not understand well so I think that it is a good product, so I made the overall evaluation a four star, it is over.
View detail