Reviews
PWK Type" For?
I was looking for replacement parts for a carburetor that was not leaking gasoline and I thought it might be overflow, and I found this one. I bought it because I thought it would probably be useful.
Float Gasket and other packings can be used.
Float also has a different shape, but I think it is Large sturdy.
The kit includes a Needle and Needle Holder, but the Needle Holder is different in size and cannot be installed. The difference in the diameter of the bleed holes can be seen when they are placed side by side. I can't install it, but even if I could, I am afraid to use it. I was swearing to myself that I should put this on even without ChalkBoots.
Buyers should check their own PWK's Size before making a purchase to avoid disappointment. Please be careful.
The Gasoline leak was not fixed, although it was attached where it could be attached. We are continuing with the repair work because we were able to eliminate one of the negatives for the time being.
View detail
correction of post (to a post)
I made a Screw Pitch mistake in the first Review, so I am correcting it.
KEIHIN's Slow Jet was M3.5×0.6.
The Slow Jet included is M4×0.7.
View detail
The product itself is good. However, it is partly different from the product description.
The carburetor itself has a good texture and can be used normally!
However, there is a difference from the product description.
I thought I had inadvertently over-tightened the 1st pc. and the Throw Screw Pitch was crushed, so I bought another one of the same carburetor and noticed that the Screw Pitch was different between the #35 that came with the DeFault and the #35 that came with the KEIHIN PC20 that I had on hand&. hellip;.
Perhaps the Slow Jet that came with it is M4×0.7 and KEIHIN's Slow Jet is M3.5×0.5.
However, the screw threads are shallow and the pitch is slightly different, so the screw threads on the body side are crushed when installing and removing for setting.
Incidentally, the product description states that KEIHIN-made jets can be installed.
Main jet was also Large sturdy in KEIHIN.
If you are purchasing, please be careful
View detail
It didn't work.
I used it with the ELIMINATOR 250.
The Parallel twin's Carburetor is recessed and inaccessible in the on-board condition.
So I bought this Special Tool, but unfortunately it didn't work.
I thought the tip was about 90-degrees of flex, but it's actually about 100 degrees and a bit open.
This is why the Cell Motor under the Carburetor is in the way and cannot reach the Screw.
I don't think you can use the same type of Engine, GPZ, GPX, KLE, ZZr, because the carburetor arrangement is the same.
Well, to begin with, the later years of ZZr's have the Screw hidden by the Carburetor Heater plumbing, and no tool can reach it ……
I was disappointed because the quality itself is very nice.
View detail