Reviews
Diversion to GORILLA's Custom
Purchased for repair of GORILLA, same shape as OEM Product, made of plastic, but the plating is in good condition and the price is reasonable. View detail
not bad, but ...
I think the cosmetics are better than OEM.
The plating is very clean at a glance, with no irregularities.
If you look closely, you can see vertical lines here and there that appear to be PRESS scratches? Vertical lines can be seen here and there during processing, which appear to be PRESS scratches.
I don't mind it much, but I guess those who care would be bothered by it.
There was no distortion or deformation, which is typical of Chinese Parts.
View detail
not bad
It is a Chinese part, but the plating is clean and can be used normally.
It also has a rubber cushion in the mounting hole.
View detail
It's tolerable..
I used DAYTONA 8 cm Long Swing Arm with a combination of 280 mm Rear shock.
Protection Seat is affixed to parts, Woundetc. There was not, BALI of the cut is amazing! Let's pay attention to injury.
There is no problem with the installation itself.
Although it may be attached as it is, in order to eliminate interference between Tire and Fender at the time of Stroke, we added a thin Washer instead of Color at the top of the Fender to earn a height.
Color not used sandwiched Plastic to attach Number under Tail lamp to retreat behind.
When the interference between Fender and Number is subtle, you can secure some clearance if you loosen the Carrier's installation Bolt once, raise the rear end gently and close it (^o^)
View detail
Good looking but backwards for the ct70 cables. The chrome plating looks good with only a few little marks where it was put over the welds on the mounts. The mounts them selves allow for 2 different widths of forks. It just changes the height by 10mm o
Good looking but backwards for the ct70 cables. The chrome plating looks good with only a few little marks where it was put over the welds on the mounts. The mounts them selves allow for 2 different widths of forks. It just changes the height by 10mm or so. The only problem I have with them is that the cable holder is on the wrong side for my model. Maybe for a different front end it fits right. View detail