Reviews
Fits: YAMAHA XSR900, YAMAHA MT-09 SP, YAMAHA MT-09
Size doesn't fit?
I don't know if the size is Large or if the meter is bad, but it keeps floating away, so there are always air bubbles in it. It is better than nothing. View detail
Fits: SUZUKI V-Strom 650, SUZUKI V-Strom 1000
Even if Size is past Limit….
The film is hard and fits in the MeterSize Limit. I managed to install the film, but after washing the car, the film started to float when I blew off the water droplets with a compressor.
I stuck it again, but I am not sure about its durability. Is the size still not right?
View detail
Fits: SUZUKI Hayabusa
To prevent scratches
Like the Smartphone, I bought this to prevent scratches. I found it as difficult to apply as smoked film on a car. Of course it is effective, but I would like to know how to apply it easily and beautifully. View detail
Fits: KAWASAKI H2 SX SE, KAWASAKI H2 SX, SUZUKI GSX-S1000GT, SUZUKI GSX-S1000GX
It's not cost effective
It is an old type that is difficult to put up for the price, and you have to pour water on it to remove the air. It is hard to see in the picture, but a lot of air remained. View detail
Fits: HONDA SUPER CUB C125
Spherical Panel support?
The first one was a failure, it was full of wrinkles and I threw it away immediately. the second one I pressed down slowly and radially from the Center positioning, but the air bubbles remained hard to see. It was more difficult than with a smartphone. I thought about peeling it off, but it was a waste, so I left it as it was. Would it be better to stick it with soapy water? View detail
Fits: SUZUKI Hayabusa
Meter panel
The product requires the same level of skill as a PRO to affix, and even a slight breeze when working outdoors can cause dust to stick to the adhesive and create air bubbles. View detail
Extended length of Rear Fender
It is difficult to see the effect compared to the Front side.
The price is higher than Front.
I feel like it could have been done without.
As with the front, double-sided tape is not used, but only the clip is used for mounting.
View detail
Fits: SUZUKI Katana, SUZUKI GSX-S950, SUZUKI GSX-S1000, SUZUKI GSX-R1000R L7
Construction is easy.
originally [Color] By applying the film, the clear screen will look like frosted glass.
It is my personal preference, but I thought it would be more Refreshing to cut out the Protection film from the phone.
View detail
Fits: HONDA NC750S, HONDA NC750X, HONDA Integra
Difficult to apply without air bubbles.
It is difficult to position the meter and to apply it well without air bubbles.:1pc. Fail and waste anymoreQuantity:1pc. was somewhat Gapped but not after, so the position was compromised. Considering that, this pricing is not very satisfactory. it might be enough to cut out and make it on the Universal Protective Seat with my own pattern paper. View detail
Fits: YAMAHA XSR900, YAMAHA MT-09 SP, YAMAHA MT-09
I want to get it right...
Since the film is flimsy, it easily deforms and bubbles can form in the area.
Also, the film on the main panel is slightly large, so the edges are inevitably raised.
A glare film is included, but this is not recommended for safety reasons as it makes it difficult to see the Meter.
It is a little better to buy a cheap Film from Amazon (Side Panel Film is Large here...).
View detail
Fits: SUZUKI V-Strom 250, SUZUKI GSX250R
I wonder if it's a problem with the "Skills"...?
Products are available in unglazed and glazed quantities:1 Set of 2pcs. One is a VERSION in 6 languages, and it describes how to dry install, but I tried but could not remove air bubbles. I tried but could not remove the air bubbles.:The 1pc. instruction manual English VersionVERSION had a translation (enter here for Wet installation instructions) at the bottom of the first page on the back. I thought, "This way! I tried spraying a very small amount of neutral detergent in the water, but again, I could not get rid of the air bubbles. Moreover, the adhesive strength seemed to have weakened. I read that the air bubbles would naturally disappear after a few days, but after a few days, I went for a run. (Temperature 20°C, distance 150 km) I couldn't even get any sign of the bubbles going away at all. Is this a problem with Skills? View detail
Fits: Others
Waterproof Cap
I am satisfied with the Socket itself, but the size of the attached waterproof cap is smaller than the body, so I could not use it. View detail
Fits: HONDA XL750 Transalp, HONDA X-ADV, HONDA FORZA 750, HONDA CB750 Hornet, HONDA CB1000R
Subtle!
The product is [Color] There are two sheets in the package, one clear and one matte type, and I put it on expecting the matte type. As a result, since it is matte, it does not reflect the sun light, but it is white and cloudy and I cannot see well! I peeled it off and put on Clear type. As for me, I don't want to use the matte type, so I would prefer two clear types. View detail
Hmmm... I wanted it to be at least 5,000 yen.
The OEM Inner fender was short and I was worried about the dirt and the Rear suspension.
I thought it was a bit expensive, but I couldn't find any other suitable products, so I took the plunge and bought it.
I couldn't trust the tape that came with the product, so I used my own 3M Ultra Strong Double-Sided Tape, but the first time I put it on, I put it on a little off, and it started to peel off, so I put it on again so it wouldn't shift, and now it's somehow stable.
To put it bluntly, the product itself is just black hard plastic, and I think it's worth at most a couple of thousand yen. It's more effective than nothing, but after the rain, the mud is still bouncing around.
If you had sold it for at least 5,000 yen, I might have been satisfied...
View detail
Fits: HONDA SUPER CUB C125
I can't get it to stick.
I can't get in properly.Quantity:1pc. failed. 2pc. failed. View detail
Fits: HONDA 400X, HONDA CB500F, HONDA CB500X, HONDA CB650R, HONDA CBR400R, HONDA CBR500R, HONDA CBR650R
Film texture is very nice.
The matte texture makes it easy to see the Panel, but within a month, it peeled off from the edges. View detail
Fits: KAWASAKI Z900RS, KAWASAKI Z650RS
Hard to put up, unlike a phone!
It is a feeling of the protection film of the age of GALAKAY, and it is extremely difficult to stick it beautifully.
I think it's deadly when dust gets in!
View detail
Fits: KAWASAKI Z900, KAWASAKI Z650, KAWASAKI Z400
Recommendation.
I failed.
I wanted Antiglare.
View detail
Fits: BMW S1000R, BMW F900R, BMW S1000RR, BMW S1000XR
2
I cut it about 15mm because it makes contact with the Tire
Still, Clearance is no more than 5 millimeters
I think it's a Universal Product, not 900RSpec
View detail
Fits: HONDA 400X, HONDA CB500F, HONDA CB500X, HONDA CB650R, HONDA CBR400R, HONDA CBR500R, HONDA CBR650R
mistake
I was planning to buy another Manufacturer's item, but they didn't have it in stock, so I chose this one for immediate delivery But when I installed it, I found out that Quantity:Pair (for Left and Right) And also Film floats I thought that the degreasing had failed and started again from the first degreasing and used the attached Quantity:I tried 1pc. and it still floats I don't think it's going to come off, but I was surprised to see this much for this Gold amount I thought it was a very disappointing product View detail