Reviews
For bremboOEMHose
[How is it used?
Brembo master is installed on MainMotorcycle's XJR1300C and Racer's YZF-R25 MASTER.
Oil hose from bremboOEM is 9.5Φ Clip that comes with brembo tank kit is not so good......................................
I was looking for a good hose clamp and found this product.
So far, the Fluid leakage and other problems have been completely solid, so I can safely recommend it.
Was the one you received as per Image?
The surface finish is even better than Image's! The price is cheap and the two-pack is easy to use.
Was the installation difficult?
It's not hard to do
Even if you want to replace only the clips, you have to disconnect the oil hose once.
I think it is better to do it with Timing to remove Brake fluid such as Fluid replacement.
How was your experience with it?
In a good way, it is insanely hard. It's tough to spread Clamp with bare hands.
It should be properly pinched and spread with radio pliers, but it is better to apply Dustcloth or something else before applying the tool because it is easy to scratch it.
Also, it is quite tight when passing through the Nipple section. If you try to pry too hard, you may damage the Nipple side.
After moistening the brake hose with Parts Cleaner or similar, slide it into the brake hose.
It can be installed without giving Stress to the surrounding Parts.
[Included Parts:were they on?
As shown in the picture, ClampQuantity:2pc. Nothing but Set.
[Was there anything that disappointed you?
Nothing in particular. If I had to say, I'd say it's too hard and could be softened a bit.
I think the knob could be made a little bit larger to make it even easier to use.
View detail