Reviews
Lever Replacement
Brake lever, I have been wanting to replace it for a while and was curious to buy this one.
After much deliberation over whether to go for the short or middle type, I decided to go for the middle type, which was in stock.
Looks and uses don't seem to be too bad.
View detail
Short may be too short?
Only the movable part of the lever was replaced because I didn't like the thick feeling peculiar to bremboLever.
I selected Short, but it is much shorter. It's just enough to get your middle finger over the end, index and middle finger Quantities.:It is just about right for 2pcs. Personally, I thought it was too short, so I will buy a Middle.
View detail
Brake master lever replacement
The CORSA Corta Lever is slim and I felt uncomfortable from the thicker Lever I had been used to, so I replaced it with Koken's AeroLever.
Basically the finger Quantity:Since it is a 2pc hang, I selected the Short lever which is available in stock.
However, the grip was as expected, but it was too warped compared to the OEM Lever, or maybe it is because we have small hands, or maybe the Lever was too far away and we failed even though we set it at the front of the Lever adjustment range of the CORSA Corta….
At any rate, I managed to get to the acceptable Limit position by changing the CORSA Corta Lever play from NORMAL to SPORTS.
Normally, I would prefer the RACING position, which is much closer, but since it is play 0, I thought I would get used to the Sports Response for a while, and if it feels uncomfortable, I would try the RACING position.
I often put my finger on the tip of the lever, but is the base of the lever (closest part) correct? （Is it correct to put your finger on the base of the lever (the part closest to the base of the lever)? If you put your finger near the tip of the lever, the lever may be too far away.
View detail
If you use Brembo master with electronic ThrottleMODEL, replacement is recommended.
[How is it used?
When we replaced the brembo radial master cylinder on the StreetTripleRS, there was a problem with the lever interfering with the throttle holder due to the thickness of the switch box and throttle holder.
The AeroLever from Kohken was replaced not only to reduce air pressure pushing in the lever by cutting out the wall, but also to prevent interference with the throttle holder since the shape around the throttle holder is slimmer than that of the brembo lever. The new lever is a very good solution for the problem of the throttle holder.
Was the one you received as per Image?
When stacked with the brembo lever, the shape around the throttle holder is indeed thinner, which seems to reduce interference when gripping.
Since there was no Large change in the shape of the fingers, there was no discomfort in the fingering after the replacement.
Was the installation difficult?
Since only the movable part of the Lever is replaced, it can be replaced by removing and replacing the Bolt1 pc.
How was your experience with it?
I have not yet tested it with the actual lever coming in at Circuit, but from the feel of holding it, there is definitely more clearance with the Throttle holder than there was before the replacement.
If this does not seem to work, the only way is to add a Remote adjuster or something to be able to adjust it while driving.
[Included Parts:were they on?
Since only the retractable portion of the Lever is available, it cannot be replaced without the Retractable Lever.
[Was there anything that disappointed you?
As mentioned above, since there is only a movable portion of the Lever, the price seems expensive when considered on its own.
However, we are willing to split the cost if it will improve the usability of Brake more than that.
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
View detail